This thin lubricant penetrates into tight spaces, and nano-sized additives fill small surface imperfections, reducing wear and heat and extending the life of both the lubricant and equipment.

For use in food-processing and preparation areas, these thin, multipurpose lubricants are NSF registered H1 for incidental food contact.

Protect food-processing and preparation equipment while limiting environmental impact. These multipurpose lubricants are NSF registered H1 for incidental food contact and are rated to quickly break down in water.

Formulated to adhere to metal parts and stay in place in wet environments, this grease is commonly used in pulp and paper manufacturing and water management facilities.

Waterproof and heat-resistant, this grease can be autoclaved without washing out of equipment. It's chemically inert, so it won't interact with process fluids.

Brush on most metal surfaces to provide a layer of protection against corrosion.

For use in applications where acids, bases, oxidizers, and fuels are present.

This grease comes in cartridges that only work with our Controlled-Use Food-Grade Lever-Grip Grease Guns to make sure that the right grease is used in food-processing areas. It is NSF registered H1 for incidental food contact.

Apply directly to seals and O-rings to extend service life by preventing drying and cracking.

Fluorocarbon and fluorinated polymer thickeners add chemical resistance to this grease. It remains intact when exposed to water and most solvents and chemicals.

This grease meets NSF/ANSI Standard 51 and FDA 21 CFR 175.300 for direct contact with food and NSF/ANSI Standard 61 for use with components that come into contact with drinking water.

These lubricants go on wet for easy application. Once dry, they form a nonstick film that won't attract dust. Use them for general purpose lubricating in most applications.

Nano-sized additives fill small surface imperfections, reducing wear and heat to extend the life of both the lubricant and equipment. These lubricants dry to form a nonstick film that won’t attract dust. They are often used on hinges, gears, and roller chain.

Use at pressures up to 50,000 psi.

Apply directly to seals and O-rings to extend service life by preventing drying and cracking.

For hoses and other tight-fitting parts, apply these lubricants to rubber or plastic before assembling and disassembling. After drying, they lose their lubricity, so parts stay together. They leave no residue on assembled parts.

Made of graphite, these powders and flakes lubricate under heavy loads and high temperatures. They resist most chemicals and conduct heat and electricity. Use them dry or mix with oil and grease.