Tap and splice multiple wires in temporarily wet environments and up to six feet underground. Made with an EPDM rubber housing, these splices are fully insulated. Trim-to-size wire port plugs create a tight seal for wire entry, and removable screw-in plugs with double O-rings tightly seal the screw openings. All are UL and C-UL listed as meeting American and Canadian safety standards. These splices are for use with Class B and C wire types.

Filled with gel, these taps seal out moisture. Use them to connect a tap wire to a main wire without stripping—they penetrate insulation. To install, squeeze the tap with standard pliers; a built-in U-shaped metal contact penetrates the insulation and grips the wire.

For technical drawings and 3-D models, click on a part number.

Connect a tap wire to a main wire without stripping—these wire taps penetrate insulation. To install, squeeze the tap with standard pliers; a built-in U-shaped metal contact penetrates the insulation and grips the wire.

For technical drawings and 3-D models, click on a part number.

These wire taps meet UL 94 V-2 for flame retardance. Use them to connect a tap wire to a main wire without stripping—they penetrate insulation. To install, squeeze the tap with standard pliers; a built-in U-shaped metal contact penetrates the insulation and grips the wire.

For technical drawings and 3-D models, click on a part number.

Tap a wire or add a finished terminal to the end of a wire. Crimp the parallel tap onto the line you wish to tap, and insert the snap plug into the parallel tap. Parallel tap and snap plug are sold separately.

Splice large wire sizes without special tools—insert your wires and tighten the hex nut to make a connection. The hex nut can be loosened to disconnect if needed.

For technical drawings and 3-D models, click on a part number.

Use the included crimping tool to install a variety of terminals and butt splices.