Each lockout rotates into itself, making installation in tight spaces easier than other lockouts. All prevent valve handles from turning and include write-on labels. They help you comply with OSHA 29 CFR 1910.147 procedures for the control of energy sources that could injure workers.

Prevent valve hand wheels from turning. These lockouts help you comply with OSHA 29 CFR 1910.147 procedures for the control of energy sources that could injure workers.

Lock out most valves in your facility with just one device. These lockouts clamp onto a variety of valve handwheels and handles. They’re great for large levers, T-handles, wheels with odd shapes and sizes, and other handles that are hard to secure with specialized lockouts. However, they’re slower to install than specialized lockouts—you’ll have to configure different attachments depending on your handle type. These lockouts help you comply with OSHA 29 CFR 1910.147 requirements for the control of hazardous energy.

To install, first turn your handle to the off position. After assembling your lockout with all necessary attachments, clamp the body to your handle and turn the lockout wheel to tighten. Add a padlock to prevent removal of the lockout.

Each lockout comes with a blocking arm. Wedge the arm against a pipe or other surface in the direction the handle turns in—this will block its movement. If your handle turns in either direction, attach an additional blocking arm (sold separately).

For valve handles that turn with a squeeze trigger, clamp the lockout body to the handle so it wedges between the handle and the trigger.

For handwheels, clamp the lockout body to the edge of the wheel and run the included cable through the spokes and around a nearby pipe or surface. Then pull the cable through the lockout body for a tight hold.

Each lockout rotates into itself, making installation in tight spaces easier than other lockouts. The lockouts are red. They help you comply with OSHA 29 CFR 1910.147 procedures for the control of energy sources that could injure workers.

Keep everything you need to lock out most electrical equipment and valves around your facility in a single spot against the wall. These sets have supplies for locking out circuit breakers, valves, plugs, wall switches, and other controls. The supplies are red or yellow to alert people to maintenance. They help you comply with OSHA 29 CFR 1910.147, which requires power sources and supply lines to be locked out to prevent injuries.

Lock out nearly any power source or supply line in your facility, from circuit breakers and valve handles to wall switches and air hose. These sets include padlocks, hasps, and other lockouts in a carrying case—just grab them and go. They also include a cable lockout for panel boxes, handwheels, and other devices that require extra length to secure. To alert others to maintenance and repair, the lockouts are red. The lockouts in these sets help you meet OSHA 29 CFR 1910.147 requirements to prevent injuries caused by accidental startups.

Everything you need to safely lock out nearly every valve in your facility—these sets include adjustable ball valve and wheel lockouts along with a universal and cable lockout to tackle unusually shaped valves. Eye-catching red padlocks, hasps, and lockouts alert others to the maintenance and signal they should proceed with caution. Use them on compressed air, hydraulic fluid, fuel, and other potentially dangerous lines. These lockouts help you comply with OSHA 29 CFR 1910.147 requirements to prevent injuries from valves being accidentally opened during maintenance.

Everything you need to lock out your electrical equipment or valves. These sets are your one stop shop for padlocks, hasps, and other lockout devices. Bright red, they alert others to service or repairs. Use them to comply with OSHA 29 CFR 1910.147 requirements to prevent injuries caused by accidental startups during maintenance.