Clear All
Mounting Location Mounting Location |
|---|
 | DIN Rail |
Number of Circuits Controlled Number of Circuits Controlled |
|---|
|
Switching Current Switching Current | Show |
|---|
|
Switching Current Switching Current | Hide |
|---|
Number of Terminals Number of Terminals |
|---|
|
Switch Starting Position Switch Starting Position |
|---|
|
Industry Designation Industry Designation |
|---|
|
Component Component |
|---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement)  |
|---|
Width Width |
|---|
|
Switch Type Switch Type |
|---|
|
Height Height |
|---|
|
Depth Depth |
|---|
|
Wire Connection Type Wire Connection Type |
|---|
 | Screw Terminals |
Choosing an Electrical Switch
More
Two-Hand Safety Switches
It takes two hands to activate these switches, minimizing the risk of accidental equipment start up. A complete system requires two switches, one safety relay, and two outlet boxes.
Safety relays control the two switches by sending an output signal when both switches are activated within 0.5 seconds of each other. Self-monitoring circuitry offers additional protection—if any part of the system fails, the entire system shuts down until repaired.
For technical drawings and 3-D models, click on a part number.
Safety Relays
Safety Relay
| Input Voltage | No. of Circuits Controlled | Switch Starting Position | No. of Terminals | Industry Designation | Switching Current @ Voltage | For DIN Rail Ht., mm | Wire Connection Type | Each | |
| 24V AC/DC | 2 | 2 Off (Normally Open) | 4 | DPST-NO | 4 A @ 230 V AC, 2 A @ 24 V DC | 35 | Screw Terminals | 00000000 | 0000000 |
| 115V AC | 2 | 2 Off (Normally Open) | 4 | DPST-NO | 4 A @ 230 V AC, 2 A @ 24 V DC | 35 | Screw Terminals | 00000000 | 000000 |