The assorted tools in these sets are used to hold, separate, and position wire, springs, and other small parts.

Sets include a handle and an assortment of tips for holding and positioning wire, springs, and other small parts.

A different tip at each end allows you to install, extract, and position parts with one tool.

The handles of these assorted picks have a magnet at the end to pick up small steel objects. Use to hold and position wire, springs, and other small parts.

Avoid nicking or scratching sensitive components. Also known as spudgers, these picks are good for adjusting small wires or separating press-fit plastic components.

Solder won’t stick to these assorted picks, which are used for positioning circuit board components.

These assorted picks have insulated handles that protect against accidental contact with live electrical circuits. They are tested to 1,000 volts to meet IEC 60900 and ASTM F1505.

Similar to dental instruments, these needle-sharp picks are suitable for work around delicate circuits and components.

Pull material out of tight spots. Similar to removing a cork from a bottle, the tip twists into material to provide a firm hold while the handle provides the necessary leverage for pulling.

Replace tips when they become worn or to use a different style. The corkscrew tip twists into material to provide a firm hold while the handle provides the necessary leverage for pulling.

Made of beryllium copper with an aluminum-bronze handle, these pullers satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present. Use to extract material from tight spots.

A different tip at each end installs and positions tiny springs and wires. Unlike conventional picks that have pointed tips, these are rounded to prevent damage to sensitive components.

Shaped for removing the seals around bearings, insert the tip of these tools behind the seal and pull. The curved head provides leverage to remove stuck and stubborn material.