These spacers have excellent corrosion resistance and are passivated for enhanced protection.

Choose titanium spacers for their high strength-to-weight ratio and excellent corrosion resistance.

Naturally slippery and wear resistant, acetal spacers also offer some resistance to moisture.

Use PEEK spacers as an alternative to metal spacers in high-temperature, high-stress applications. They resist chemicals, wear, and moisture.

Choose the OD, ID, length, and material and we will accommodate your unique spacer needs.

These standoffs are made to NAS specifications.

Choose these standoffs for their adherence to NAS 1831 specifications.

Once the end is clinched in place, panels with keyholes easily slide on and off these supports.

When you’ve applied the correct tension, these washers release an orange dye as a visual indicator.

These shims are made of layers of metal bonded with adhesive. Remove layers with a utility knife until you get the thickness you need.

Cut this stock into custom shapes to fit your application.

Cut this shim stock into custom shapes to fit your application. Stock is made of layers of material bonded with adhesive; remove layers with a utility knife until you get the thickness you need.

The slot lets you install these rigid shims around screws.

The textured surface of these thick shims keeps them from sliding apart when stacked. Use them to align cabinets, doors, and windows, or for other rough leveling.

Send us a drawing, and we'll cut your custom shim. Shims are made of layers of metal bonded with adhesive; remove layers with a utility knife until you get the thickness you need.

In addition to joining male- and female-threaded parts, these adapters can increase or decrease metric thread sizes and change the thread pitch.

Need to join two female-threaded parts, such as coupling nuts, with dissimilar inch thread sizes? Attach them to these adapters and tighten the exterior hex nut for a secure connection.

One side inch, one side metric, and a hex in the middle—these handy fasteners connect two female-threaded parts, such as coupling nuts, adapting from inch threads to metric. Tighten with a standard wrench.