McMaster-Carr logo
    Clear All
    Component
    Component
    Show
    Worm
    System of Measurement
    System of Measurement
    Inch
    Metric
    For Shaft Diameter
    For Shaft Diameter
    default
    1/2"
    5/8"
    3/4"
    7/8"
    5 mm
    6 mm
    8 mm
    10mm
    12mm
    15mm
    Gear Pitch
    Gear Pitch
    click to learn more about
    Gear Type
    Gear Type
    Worm
    Bore Type
    Bore Type
    RoundKeyed
    Gear Pitch Diameter
    Gear Pitch Diameter
    default
    1"
    1 1/4"
    1 1/2"
    2"
    11mm
    14mm
    16mm
    21mm
    25mm
    31mm
    37mm
    Pressure Angle
    Pressure Angle
    14 1/2°
    20°
    Material
    Material
    Steel
    Stainless Steel
    Number of Thread Starts
    Number of Thread Starts
    1
    2
    Module
    Module
    click to learn more about
    Thread Direction
    Thread Direction
    click to learn more about
    Keyway Width
    Keyway Width
    default
    1/8"
    0.188"
    Keyway Depth
    Keyway Depth
    default
    0.063"
    0.094"
    Teeth Heat Treatment
    Teeth Heat Treatment
    Hardened
    Not Hardened
    Teeth Fabrication
    Teeth Fabrication
    Not Ground
    Ground
    RoHS (Restriction of Hazardous Substances)
    RoHS (Restriction of
    Hazardous Substances)
    RoHS Compliant
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    click to learn more about
    REACH (Registration, Evaluation, Authorization and Restriction of Chemicals)
    REACH (Registration,
    Evaluation, Authorization
    and Restriction of Chemicals)
    REACH Compliant
    Set Screw Included
    Set Screw Included
    Yes
    No
    Hub Diameter
    Hub Diameter
    default
    20 mm
    25 mm
    30 mm
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    25 Products