Roller Chain Trade Size Roller Chain Trade Size |
---|
|
System of Measurement System of Measurement |
---|
|
For Shaft Diameter For Shaft Diameter |
---|
|
For Maximum Shaft Diameter For MaximumShaft Diameter | Show |
---|
|
For Maximum Shaft Diameter For MaximumShaft Diameter | Hide |
---|
Component Component |
---|
![]() | Gear |
For Roller Chain Strand Type For Roller Chain Strand Type |
---|
![]() | Double |
Bore Type Bore Type |
---|
![]() | ![]() |
Machinable | Round |
Gear Pitch Gear Pitch |
---|
Gear Type Gear Type |
---|
![]() | Spur |
Material Material |
---|
|
Pressure Angle Pressure Angle |
---|
|
ID ID |
---|
|
For Shaft Type For Shaft Type |
---|
![]() | Round |
REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration,Evaluation, Authorization and Restriction of Chemicals) |
---|
|
RoHS (Restriction of Hazardous Substances) RoHS (Restriction ofHazardous Substances) |
---|
|
Teeth Heat Treatment Teeth Heat Treatment |
---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
---|
About Roller Chain and Sprockets
More
About Gears
More
Sprockets for Double-Strand ANSI Roller Chain


These sprockets come machined to the shaft diameter size listed and are machinable up to the maximum shaft diameter size. All have hardened teeth for increased wear resistance and a long service life.
For technical drawings and 3-D models, click on a part number.
Number of Teeth | For Shaft Dia. | For Max. Shaft Dia. | OD | Overall Wd. | Hub Dia. | Material | Each | |
For ANSI 50-2 Roller Chain (5/8" Pitch) | ||||||||
---|---|---|---|---|---|---|---|---|
19 | 1" | 2 1/8" | 4.12" | 1 3/4" | 3 1/8" | Steel | 0000000 | 0000000 |
Metal Gears and Gear Racks—14 1/2° Pressure Angle
A former industry standard, 14½° pressure angle gears are often found on older machinery. Made of carbon steel, they have high strength and are better than plastic gears and gear racks for high-load, high-speed, and heavy duty applications.
Combine gears with different numbers of teeth to change speed and torque in your assembly. Combine a gear and rack to convert rotary motion into linear motion.
For components to mesh correctly, they must have the same pressure angle and pitch.
Gears with machinable bore have a large hub diameter so you can machine them to fit your shaft.
Gears with teeth that are not hardened can be hardened to fit your application. Hardening a gear's teeth increases its wear resistance.
For technical drawings and 3-D models, click on a part number.


Hub | ||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|
Gear Pitch | Number of Teeth | Gear Pitch Dia. | OD | Face Wd. | Overall Wd. | For Shaft Dia. | Material | Teeth Heat Treatment | Dia. | Wd. | Each | |
Round/Machinable Bore | ||||||||||||
6 | 36 | 6" | 6.33" | 1 1/2" | 2.5" | 1 1/8"-2 1/8" | 1144 Carbon Steel | Not Hardened | 3.25" | 1" | 00000000 | 0000000 |