McMaster-Carr logo
    Clear All
    Speed Ratio
    Speed Ratio
    3:1
    System of Measurement
    System of Measurement
    Metric
    For Shaft Diameter
    For Shaft Diameter
    Show
    12 to 30 mm
    Module
    Module
    click to learn more about
    Component
    Component
    Gear
    Bore Type
    Bore Type
    MachinableRound
    Gear Pitch Diameter
    Gear Pitch Diameter
    default
    90mm
    Number of Teeth
    Number of Teeth
    45
    Hub Diameter
    Hub Diameter
    default
    40mm
    Gear Type
    Gear Type
    Spiral Bevel
    Material
    Material
    Steel
    Finish
    Finish
    Black Oxide
    Hub Width
    Hub Width
    default
    17 mm
    Face Width
    Face Width
    default
    15mm
    Overall Width
    Overall Width
    default
    30.3 mm
    Teeth Fabrication
    Teeth Fabrication
    Not Ground
    For Maximum Shaft Diameter
    For Maximum Shaft Diameter
    30 mm
    REACH (Registration, Evaluation, Authorization and Restriction of Chemicals)
    REACH (Registration,
    Evaluation, Authorization
    and Restriction of Chemicals)
    REACH Compliant
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    click to learn more about
    Pressure Angle
    Pressure Angle
    20°
    RoHS (Restriction of Hazardous Substances)
    RoHS (Restriction of
    Hazardous Substances)
    RoHS Compliant
    Teeth Heat Treatment
    Teeth Heat Treatment
    Hardened
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    2 Products