A former industry standard, 14½° pressure angle gears are often found on older machinery. Made of carbon steel, they have high strength and are better than plastic gears and gear racks for high-load, high-speed, and heavy duty applications.

Combine gears with different numbers of teeth to change speed and torque in your assembly. Combine a gear and rack to convert rotary motion into linear motion.

For components to mesh correctly, they must have the same pressure angle and pitch.

Gears with machinable bore have a large hub diameter so you can machine them to fit your shaft.

Gears with teeth that are not hardened can be hardened to fit your application. Hardening a gear's teeth increases its wear resistance.

For technical drawings and 3-D models, click on a part number.

The current industry standard, these 20° pressure angle gears have thicker, stronger teeth than 14½° pressure angle gears. Compared to plastic gears and racks, they’re better for high-load, high-speed, and heavy duty applications. Also known as spur gears.

Combine gears with different numbers of teeth to change speed and torque in your assembly. Combine a gear and rack to convert rotary motion into linear motion. To minimize your footprint, mount one or more standard gears inside of an internal gear.

For components to mesh correctly, they must have the same pressure angle and pitch/module.

Carbon steel components have hard, strong, and wear-resistant teeth, although they will rust when exposed to moisture and corrosive chemicals. They're best for high-torque machines, like lifting equipment, and heavy duty applications, such as rock crushing. Gears with teeth that are not hardened can be hardened to fit your application.

For technical drawings and 3-D models, click on a part number.

Also known as spiral miter gears, these gears have curved teeth that stay in contact longer than straight teeth so they handle heavier loads at higher speeds. They run quieter than standard miter gears because the teeth gradually engage. Use them to transmit motion at a right angle while maintaining shaft speed and torque. Gears are carbon steel for strength. Teeth are hardened for wear resistance.

Gears must be identical in order to mesh correctly; they're sold as a pair.

For technical drawings and 3-D models, click on a part number.