Number of Teeth Number of Teeth |
|---|
|
System of Measurement System of Measurement |
|---|
|
Material Material |
|---|
|
Bore Type Bore Type |
|---|
 | Round |
OD OD | Show |
|---|
|
OD OD | Hide |
|---|
Component Component |
|---|
|
Hub Diameter Hub Diameter |
|---|
|
Gear Type Gear Type |
|---|
 | Ratchet |
Teeth Heat Treatment Teeth Heat Treatment |
|---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
|---|
Mounting Distance Mounting Distance |
|---|
|
Bushing Type Bushing Type |
|---|
|
Fastener Tightening Torque Fastener Tightening Torque |
|---|
|
ID ID |
|---|
|
Maximum Torque Maximum Torque |
|---|
|
Shaft Mount Type Shaft Mount Type |
|---|
|
About Gears
More
Flush-Mount Screw-Clamp Bushings
Insert these bushings into the bore of your sprocket for flush or recessed mounting. They handle shock loads and have higher torque ratings than self-centering bushings. When you tighten the included clamping screws, the bushing's inner sleeve contracts onto the shaft and the outer sleeve expands to hold your sprocket, pulley, or gear. They can be mounted on shafts with or without keyways.
For technical drawings and 3-D models, click on a part number.
| For Shaft Dia. | OD | Overall Wd. | Max. Torque, in.-lbs. | Fastener Tightening Torque, in.-lbs. | Material | Includes | Each | |
| 150mm | 200mm | 116mm | 672,150 | 1,992 | Steel | Clamping Screws | 0000000 | 000000000 |
Metal Ratcheting Gears
Compared to plastic gears, these metal ratcheting gears are better for high-load, high-speed, and heavy duty applications. Used to prevent unwanted motion in jacks, tie downs, clutches, and winches, ratchet gears have sloped teeth that allow motion in one direction and prevent it in the other.
Gears with hardened teeth are more wear resistant than gears with teeth that are not hardened.
For technical drawings and 3-D models, click on a part number.
