With straight, conically shaped teeth and a 1:1 speed ratio, miter gears connect two shafts at an angle without changing shaft speed or torque. They're more efficient than spiral miter gears because they create less friction.

For two gears to mesh correctly, they must have the same pressure angle, shaft angle, pitch/module, and number of teeth.

Stainless steel gears won’t rust in damp or wet environments. They’re commonly used in food-processing plants and other areas where frequent cleaning takes place.

For technical drawings and 3-D models, click on a part number.

Metric Gears

For 90° Shaft Angle

											Hub
Module	Number of Teeth	For Shaft Angle	Pressure Angle	Gear Pitch Dia., mm	OD, mm	Face Wd., mm	Overall Wd., mm	For Shaft Dia., mm	Mounting Distance, mm	Teeth Heat Treatment	Dia., mm	Wd., mm	Set Screw Thread Size		Each
Round Bore with Set Screw—303 Stainless Steel
1.5	25	90°	20°	38	39.6	9	22.3	10	34	Not Hardened	30	11.5	M4	0000000	000000

Plastic Miter Gears

Gears Sold Separately

Connect two shafts at a right angle without changing shaft speed or torque. Made of plastic, these gears run quieter than metal gears and have good corrosion and chemical resistance.

For two gears to mesh correctly, they must have the same pressure angle, pitch/module, and number of teeth.

Nylon gears are self-lubricating, so they’re often used in food machinery. However, they’re not approved for direct contact with food or chemicals that will come into contact with food.

For technical drawings and 3-D models, click on a part number.

Metric Gears

												Hub
Module	Number of Teeth	Pressure Angle	Gear Pitch Dia.	OD, mm	Face Wd., mm	Overall Wd., mm	For Shaft Dia., mm	Mounting Distance, mm	Material	Fabrication	Color	Dia., mm	Wd., mm		Each
Round Bore
1.5	25	20°	37.5mm	39.6	9	22	8	34	Nylon Plastic	Molded	Blue	30	11.5	00000000	000000

2 Products

About Gears

Metal Miter Gears

Plastic Miter Gears