Clear All
Roller Chain Trade Size Roller Chain Trade Size |
|---|
|
Number of Teeth Number of Teeth |
|---|
|
System of Measurement System of Measurement |
|---|
|
For Shaft Diameter For Shaft Diameter |
|---|
|
Material Material |
|---|
|
Bore Type Bore Type |
|---|
 | Finished |
OD OD | Show |
|---|
|
OD OD | Hide |
|---|
ID ID |
|---|
|
Bearing Type Bearing Type |
|---|
 | Ball |
For Roller Chain Strand Type For Roller Chain Strand Type |
|---|
 | Single |
Bearing Material Bearing Material |
|---|
|
Bearing Seal Type Bearing Seal Type |
|---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
|---|
Hub Diameter Hub Diameter |
|---|
|
Roller Chain Standard Roller Chain Standard |
|---|
|
Shaft Mount Type Shaft Mount Type |
|---|
|
Sprocket Type Sprocket Type |
|---|
|
Teeth Heat Treatment Teeth Heat Treatment |
|---|
|
For Shaft Type For Shaft Type |
|---|
 | Round |
Overall Width Overall Width |
|---|
|
About Roller Chain and Sprockets
More
Wear-Resistant Idler Sprockets for ANSI Roller Chain
Hardened teeth give these steel sprockets increased wear resistance for a long service life. Designed to rotate freely on built-in bearings, idler sprockets maintain constant tension on your drive by pressing against your chain to take up slack and reduce wear and vibration. They are for use with roller chain tensioners.
Ball bearings are double sealed to keep dirt out.
For technical drawings and 3-D models, click on a part number.
Bearing | |||||||||
|---|---|---|---|---|---|---|---|---|---|
| Number of Teeth | For Shaft Dia. | OD | Overall Wd. | Hub Dia. | Material | Type | Material | Each | |
For ANSI 50 Roller Chain (5/8" Pitch) | |||||||||
| 39 | 3/4" | 8.12" | 39/64" | 1 3/4" | Steel | Ball | Steel | 00000000 | 000000 |