System of Measurement System of Measurement |
---|
|
Material Material |
---|
|
Component Component |
---|
![]() | Gear |
Module Module |
---|
Speed Ratio Speed Ratio |
---|
|
Bore Type Bore Type |
---|
![]() | Round |
Gear Type Gear Type |
---|
![]() | Miter |
Set Screw Thread Size Set Screw Thread Size |
---|
|
Overall Width Overall Width | Show |
---|
|
Overall Width Overall Width | Hide |
---|

Pressure Angle Pressure Angle |
---|
|
REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration,Evaluation, Authorization and Restriction of Chemicals) |
---|
|
RoHS (Restriction of Hazardous Substances) RoHS (Restriction ofHazardous Substances) |
---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
---|
Teeth Heat Treatment Teeth Heat Treatment |
---|
|
About Gears
More
Metal Miter Gears



With straight, conically shaped teeth and a 1:1 speed ratio, miter gears connect two shafts at an angle without changing shaft speed or torque. They're more efficient than spiral miter gears because they create less friction.
For two gears to mesh correctly, they must have the same pressure angle, shaft angle, pitch/module, and number of teeth.
Carbon steel gears have hard, strong, and wear-resistant teeth. They’re best for heavy duty and high-torque applications, such as lifting equipment. However, these gears will rust when exposed to moisture or corrosive chemicals. Some gears have hardened teeth for additional wear resistance; gears with teeth that are not hardened can be hardened to fit your application.
Stainless steel gears won’t rust in damp or wet environments. They’re commonly used in food-processing plants and other areas where frequent cleaning takes place.
For technical drawings and 3-D models, click on a part number.



Hub | |||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Module | Number of Teeth | For Shaft Angle | Pressure Angle | Gear Pitch Dia., mm | OD, mm | Face Wd., mm | Overall Wd., mm | For Shaft Dia., mm | Mounting Distance, mm | Teeth Heat Treatment | Dia., mm | Wd., mm | Set Screw Thread Size | Each | |
Round Bore—1045 Carbon Steel | |||||||||||||||
1.5 | 20 | 60° | 20° | 30 | 32.6 | 9 | 22.3 | 8 | 40 | Not Hardened | 25 | 12.6 | __ | 0000000 | 000000 |
Round Bore with Set Screw—303 Stainless Steel | |||||||||||||||
1.5 | 25 | 90° | 20° | 38 | 39.6 | 9 | 22.3 | 10 | 34 | Not Hardened | 30 | 11.5 | M4 | 0000000 | 00000 |