65 Products

Insert these bushings into the bore of your sprocket for flush or recessed mounting. They handle shock loads and have higher torque ratings than self-centering bushings. When you tighten the included clamping screws, the bushing's inner sleeve contracts onto the shaft and the outer sleeve expands to hold your sprocket, pulley, or gear. They can be mounted on shafts with or without keyways.

For technical drawings and 3-D models, click on a part number.

A type of miter gear where one gear (sometimes called a pinion) is smaller than the other, bevel gears provide right-angle speed reduction at speed ratios ranging from 2:1 to 5:1. All are carbon steel for strength; they're compatible with plastic bevel gears. Teeth are not hardened so you can harden them to fit your application. Hardening a gear’s teeth increases its wear resistance.

A complete set consists of a gear and pinion (sold separately). For a gear and pinion to mesh correctly, they must have the same pressure angle, pitch/module, and face width. Shaft-mounted pinions come already securely fastened to a shaft.

Speed ratio is the ratio by which shaft speed is reduced when transferring motion from pinion to gear. To increase shaft speed, transfer motion from gear to pinion. Changing shaft speed also changes torque: as speed decreases, torque increases.

For technical drawings and 3-D models, click on a part number.

Connect two shafts at a right angle without changing shaft speed or torque. Made of plastic, these gears run quieter than metal gears and have good corrosion and chemical resistance.

For two gears to mesh correctly, they must have the same pressure angle, pitch/module, and number of teeth.

Nylon gears are self-lubricating, so they’re often used in food machinery. However, they’re not approved for direct contact with food or chemicals that will come into contact with food.

For technical drawings and 3-D models, click on a part number.