Mount the hinge leaves to the surface of the door and the frame. These hinges are easy to install because they don't require cutouts (mortises).

Plastic hinges are a lightweight alternative to metal hinges and provide smooth, silent operation.

Thick leaves and a large diameter pin make these hinges good for use with heavy doors.

These hinges are made of metal.

Turn a set screw to adjust the door 1/8" up or down after it's hung.

Plastic hinges are a lightweight alternative to metal hinges and provide smooth, silent operation.

The hinge pin is attached to the frame leaf so you can quickly lift the door off the hinge without removing the pin.

A grease fitting makes these hinges easy to lubricate.

Springs in these hinges with holes automatically swing doors and gates closed behind you.

The springs in these hinges swing doors and gates fully open after a light push on the door.

These hinges with holes are spring loaded—pull the handle to retract the pin and disconnect a door; release the handle and the pin snaps back.

To make reconnecting doors easier than other pull release quick disconnect hinges, these have a keeper that holds the pin in a retracted position.

Remove the ring to pull out the pin.

Squeeze the hinge handles together to retract the pin and disconnect a door; release the handles and the pin snaps back.

Tighten or loosen an adjustment screw to change the hinge resistance.

A stop keeps these hinges open at a set angle; push past the stop to open them to 180°.

The mounting holes on these hinges form an industry-standard half-moon shape.

The mounting hole pattern does not follow an industry standard, which means you can work around worn mounting holes when replacing template hinges.

A stud projects from the back of each hinge leaf to prevent the door from being forced open. The mounting holes form an industry-standard half-moon shape.

The mounting hole pattern does not follow an industry standard, which means you can work around worn mounting holes when replacing template hinges.

Plastic bushings on these metal hinges prevent metal-to-metal contact that can release particles as hinges open and close.

Instead of mounting to the side of a door, mount these hinges to the top and bottom to allow doors to open wide.