Keep parts in position for machining by mounting these workstops to your vise jaws.

Mount these workstops into slotted vise jaws—they hold workpieces in place and prevent horizontal movement during machining.

The V‐shaped recess holds round material securely for machining.

Hold workpieces steady with these vise jaws—they work with slot-mount workstops so you can quickly position, adjust, and change out your workpieces.

Significantly cut down on jaw changeover time—this two-part system lets you swap out jaws in less than 30 seconds. Mount the jaw plates to the vise and slide the dovetailed jaw stock in and out of the plates.

Store vise handles near your milling machine.

Mount to a machine table to rotate a vise 360° in 1° increments.

Choose from flat and grooved liners.

Place over the jaws and tighten the screws to securely attach liners.

Insert these one-piece grooved liners between vise jaws to hold small-diameter material vertically.