Cut wood, plywood, and particleboard.

These blades have a heat-resistant coating to prevent material buildup.

Square-shaped teeth cut across the grain and with the grain (ripping) in reclaimed lumber and flooring with embedded nails.

Produce smooth cuts in plastic materials including polycarbonate, polyurethane, PVC, and acrylic with the carbide-tipped teeth on this blade.

A continuous edge on these blades produces smooth cuts.

A continuous edge on these blades produces smooth cuts. It's coated in diamond grit to cut hard, abrasive materials such as masonry, stone, asphalt, and concrete.

A blend of tungsten carbide and diamond grits on the continuous edge of these blades cuts hard, nonmetallic materials including composites and graphite.

A razor-sharp knife edge minimizes dust and makes quick, clean cuts through foam sheets such as expanded polystyrene insulation and extruded polystyrene.

Make fast, clean cuts in steel sheets, angle iron, rebar, and pipe with the carbide teeth on these blades.

Cut stainless steel sheets, pipe, tubing, and grating with teeth made of impact-resistant carbide.

Cut wood, plywood, and particleboard.

Also known as dado-head blades, these are for cutting grooves in all types of wood.

Produce smooth cuts in plastic materials including polycarbonate, polyurethane, PVC, and acrylic with the carbide-tipped teeth on these blades.

A razor-sharp knife edge minimizes dust and makes quick, clean cuts through foam sheets such as expanded polystyrene insulation and extruded polystyrene.

A continuous edge on these blades produces smooth cuts.

A continuous edge on these blades produces smooth cuts.

Make clean cuts in rubber and plastic hose with the scalloped knife edge on these blades.

Teeth are carbide tipped and designed to push chips away from the blade to prevent clogging and produce smooth cuts in aluminum sheets, tubing, and T-slotted framing.

Prevent clogging when cutting soft metal—these blades have plenty of space between the carbide-tipped teeth to allow chips to escape.

Cut plastic, wood, and soft metal such as aluminum, brass, and copper.

A tungsten carbide grit edge cuts through abrasive materials such as composites and fiberglass.

Blades and teeth are steel and treated to a Rockwell Hardness between C63 and C65 for increased wear resistance when cutting through steel and cast iron bars, rods, pipe, and tubing.

These blades have a higher concentration of diamonds than other dry-cutting blades, so they last up to three times longer.