The arbor’s shank attaches to hand-held drills and die grinders. Threads on the body hold the sanding roll in place.

Attach cutoff wheels, grinding wheels, and other abrasive wheels to hand-held drills and die grinders.

Also known as cross- and square-sanding pad shank adapters, these arbors are required to attach sanding pads for internal and irregular surfaces to hand-held drills and die grinders.

Adapt flap wheels with a threaded stud for use on tools that have a threaded spindle.

Reduce the arbor hole size on a flap sanding wheel so that it fits the shaft on your tool.

Reduce the arbor hole size on a wheel brush so that it fits the shaft on your tool.

Mount wheel brushes that have an arbor hole to hand-held drills and die grinders.

Mount cutoff wheels, grinding wheels, and other abrasive discs to the straight shaft on bench-top motors, grinders, and buffers.

Secure the shank into the collet or chuck of your tool. Attach the quick-change fastener on the sanding disc to the corresponding fastener on the backup pad.

Thread these pads onto the tool’s arbor.

Thread the stud into the tool's spindle and then press the sanding disc onto the backup pad.

Thread one of these backup pads onto the tool’s arbor, then attach a sanding disc and secure with the disc nut.

Mount one of these pads onto the tool's arbor.

Use screws to attach these pads to a tool.

Thread the stud into the tool's spindle.

Slide a sanding sleeve on the drum and tighten the nut or screw to securely hold the sleeve.

Slide a flap sanding sleeve on the drum and twist the drum by hand to secure the sleeve.

Install a sanding sleeve on the threaded shaft of a bench or pedestal grinder using one of these drums.

Attach to grinder and buffer shafts to hold buffing wheels with shanks.

Mount to the straight shaft on your grinder or buffer.