The abrasive grains in these bits are blended with rubber, which cushions during grinding to produce a smoother surface texture than other bits with similar grits.

Bits thread onto mounted shanks so you can quickly switch head shapes without removing the shank. The abrasive grains are blended with rubber, which cushions during grinding to produce a smoother surface texture than other bits with similar grits.

Use bits in any drill chuck that accepts a 1/4" hex shank.

Similar to diamond, boron nitride is harder than aluminum oxide and lasts longer. Bits are also known as jig grinding pins and mandrels.

Bits stay cool during grinding so they won’t mar or discolor stainless steel.

Almost as hard as diamond, these tungsten carbide bits cut through nonmetals without generating heat.

Slip a cap onto the head of a shank and sand small, recessed, and hard-to-reach areas.

As the outer layer wears away, new abrasive is exposed.

The premium abrasive stays sharp longer.

The abrasive-embedded mesh construction gives you more control over sanding pressure, creating finer and more consistent finishes.

Sand inside pipes and tubes as well as on an angle to reach into corners and slots.

A coating prevents dust and debris from building up on the abrasive surface. These sleeves shape, deburr, and sand edges and internal surfaces.

Polish, clean, and debur deep inside tubes and cylinders.

These bobs have a long-lasting diamond abrasive.

Remove scratches from your workpiece with these hard bobs.

A titanium aluminum nitride (TiAlN) coating provides heat and wear resistance for longer life.

Extend your reach with these 3" to 7¼" long burs.

Diamond-cut teeth effectively cut hard materials.

Also known as cross- and square-sanding pad shank adapters, these arbors are required to attach sanding pads for internal and irregular surfaces to hand-held drills and die grinders.

Slide a sanding sleeve on the drum and tighten the nut or screw to securely hold the sleeve.