The abrasive-embedded nylon mesh construction gives you more control over sanding pressure.

Debur, clean, and blend faster than other nylon mesh discs.

A special fastener on the back of these discs allows you to easily swap one disc for another.

These discs have a harder abrasive than standard quick-change discs.

The outer 3/8" of these discs is extremely flexible to prevent marring or gouging your work when sanding a radius or contour.

The premium abrasive stays sharp longer.

Used for heavy cleaning and stripping, these discs have an abrasive-embedded nylon mesh construction that gives you more control over sanding pressure.

The heavy duty construction provides more support than standard discs for heavy material removal.

The thick, abrasive-embedded nylon mesh construction gives you maximum control over sanding pressure.

These discs are abrasive-embedded cloth with a cushioned layer.

Quickly attach, remove, and reuse these discs with a compatible sanding tool or backup pad.

Holes allow dust removal when used with a vacuum sander.

The mesh backing lets sanding dust and debris escape during use, preventing material build up on the abrasive surface.

The cushioned construction gives you more control over sanding pressure, creating finer and more consistent finishes.

Holes allow dust removal when used with a vacuum sander.

Press onto a compatible sanding tool or backup pad; peel off to remove.

The cushioned construction gives you more control over sanding pressure, creating finer and more consistent finishes.

Holes allow dust removal when used with a vacuum sander.

Holes allow dust removal when used with a vacuum sander.

Fit these discs over your tool's arbor.

A coating prevents dust and debris from building up on the abrasive surface.

The abrasive-embedded mesh construction gives you more control over sanding pressure, creating finer and more consistent finishes.

The premium abrasive stays sharp longer.

A coating prevents dust and debris from building up on the abrasive surface.

The premium abrasive stays sharp longer. Holes in the disc let you see the surface you’re sanding.

Fit these discs over your tool's arbor to sand masonry, ceramics, and composites.

With more flaps than standard discs, these last 30-40% longer.

With more flaps than standard discs, these last 30-40% longer.

The abrasive-embedded mesh construction gives you more control over sanding pressure, creating more consistent finishes.

The flaps alternate between an abrasive to remove material and a lubricant that minimizes heat to reduce discoloration of the work surface.

Set at an angle and widely spaced, the overlapping abrasive flaps reach into corners.

These discs have a harder abrasive than standard flap sanding discs.

The backing plate on these discs can be sheared away as the abrasive flaps wear down, allowing you to use more of the disc rather than replacing with a new one.

A coating prevents dust and debris from building up on the abrasive surface.

Use with commercial floor buffing machines to sand wood floors and strip tape from concrete.

Made of foam, these blocks flex to sand around curves.

Slits on both ends of the block allow you to attach sheets over the flat or curved side.

Secure the shank into the collet or chuck of your tool. Attach the quick-change fastener on the sanding disc to the corresponding fastener on the backup pad.

Thread these pads onto the tool’s arbor.

Holes allow dust removal when used with a vacuum sander.

Thread the stud into the tool's spindle.

Secure the shank into the collet or chuck of a tool.

These pads are designed to channel air flow to the sanding disc for cooler operation, prolonging the life of the disc.

Designed to rotate independently of the disc, these pads clear material buildup on the abrasive surface for longer disc life.

Secure the shank into the collet or chuck of a tool.