The soft abrasive is good for fine hand-polishing of metal surfaces that require the smoothest finish possible after an abrasive sequence. Also known as crocus cloth.

These rolls can be cut to length.

The soft abrasive is good for fine hand-polishing of metal surfaces that require the smoothest finish possible after an abrasive sequence. Also known as crocus cloth.

These sheets resist deterioriation when used wet or with grease, chemicals, cutting fluids, and other solvents that may be present when sanding.

Assortments include three cut-to-length sanding rolls of various grits that resist deterioration when used wet or with grease, chemicals, cutting fluids, and other solvents.

A coating prevents dust and debris from building up on the abrasive surface.

A cushioned layer gives you more control over sanding pressure, creating finer and more consistent finishes. These rolls can be cut to length.

These cut-to-length rolls resist deterioration when used wet or with grease, chemicals, cutting fluids, and other solvents that may be present when sanding. A layer of mesh lets sanding dust and debris escape during use, preventing material buildup on the abrasive surface.

A layer of mesh lets sanding dust and debris escape during use, preventing material buildup on the abrasive surface. These sheets resist deterioration when used wet or with grease, chemicals, cutting fluids, and other solvents that may be present when sanding.

Create consistent finishes on stainless steel, titanium, steel, iron, and nickel.

These sheets have a long-lasting diamond abrasive.

Cut the length you need, then quickly attach, remove, and reuse.

Quickly attach, remove, and reuse.

These sheets have a long-lasting diamond abrasive.

Quickly attach, remove, and reuse these hook-and-loop sheets with triangular detail sanders.

These sheets have a long-lasting diamond abrasive.

Quickly attach, remove, and reuse these hook-and-loop sheets with pole sanders.

Dust and debris won't build up on the abrasive surface.

Press onto a compatible sanding tool or backup pad; peel off to remove.

Holes allow dust removal when used with a vacuum sander.

The cushioned construction gives you more control over sanding pressure, creating finer and more consistent finishes.

The outer 3/8" of these discs is extremely flexible to prevent marring or gouging your work when sanding a radius or contour.

A special fastener on the back of these discs allows you to easily swap one disc for another.

The premium abrasive stays sharp longer.

The mesh backing lets sanding dust and debris escape during use, preventing material build up on the abrasive surface.

The cushioned construction gives you more control over sanding pressure, creating finer and more consistent finishes.

The flaps have an abrasive to remove material and a lubricant that minimizes heat to reduce discoloration of the work surface.

Set at an angle and widely spaced, the overlapping abrasive flaps reach into corners.

These discs have a harder abrasive than standard flap sanding discs.

These discs have a harder abrasive than standard flap sanding discs for corners.

Overlapping abrasive flaps bonded to a backing plate provide consistent material removal and even finishes.

With more flaps than standard discs, these last 30-40% longer.

These discs have a harder abrasive than standard flap sanding discs.

With more flaps than standard discs, these last 30-40% longer.

The backing plate on these discs can be sheared away as the abrasive flaps wear down, allowing you to use more of the disc rather than replacing with a new one.

Set at an angle and widely spaced, the flaps reach into corners.

Slits on both ends of the block allow you to attach sheets over the flat or curved side.

Use for finishing and light material removal. The orbital motion produces consistent finishes

Reach ceilings and high walls.