Made of slippery plastic, these bearings do not require lubrication and have excellent corrosion and chemical resistance.

Install these acetal bearings in caustic environments and where lubrication can’t be used. They have good all-around corrosion and chemical resistance.

Made of FDA-listed materials or FDA compliant, these bearings are for use in food applications. They also withstand caustic and washdown environments.

Use where high loads and speeds are not required.

Compensating for minor shaft misalignment and not requiring lubrication, these sleeve bearings swivel to self-align and are dry running. They don’t need a housing and you can install and replace them without any tools because they’re slip fit.

Use where high loads and speeds are not required.

Use these bearings in corrosive environments and under water.

Made of acetal blended with PTFE, these bearings handle speeds twice as fast as standard sleeve bearings.

Embedded lubricant particles increase the load capacity of these bearings while also making them slippery.

Made of acetal with a PTFE filling, these light duty bearings handle speeds twice as fast as standard acetal bearings can.

Use ball bearings in debris-free environments and when speed is a necessity. They operate with less friction than sleeve bearings, so you can run them at higher speeds.

Ball bearings create less friction than sleeve bearings, so they require less force to operate.

Choose ball bearings for debris-free environments and when speed is a necessity. They operate with less friction than sleeve bearings, so you can run them at higher speeds.

Outdoor as well as mild chemical environments are no problem for these bearings. They have stainless steel balls for corrosion resistance.

Mount these bearings on a support rail shaft for applications requiring maximum rigidity.

Unlike most ball transfers, which have metal balls, these have a plastic outer ball that rolls on stainless steel inner balls, so there's no metal-on-metal contact that could create and release particles into your clean room. They've also been ultrasonically cleaned and then individually bagged to prevent dust contamination.

Drop-in design makes for easy installation.

Use these bearings to replace worn and damaged bearings or press-fit them into tubing or pipe create a roller. All have a hex-shaped axle.

Also known as single-start and self-locking lead screws and nuts, these have a single thread that runs the length of the screw. The nut travels only when the screw turns, so your system won't unexpectedly move when the lead screw is at rest.

Multiple thread channels (also known as thread starts) create faster linear travel than lead screws with a single thread start.