Control flow in high-pressure lines in tight spots—these valves have the highest pressure ratings of our compact valves.

For lightweight and corrosion-resistant alternative to metal, these valves are plastic. Attach garden hose to the valve outlet. Use with water. These valves gradually open and close to adjust and regulate flow.

Insert tubing into the fitting—no heat, solder, or flux required.

The metal body is more durable than plastic.

Push tubing into these orifices, and an internal ring holds them in place. They're for use with plastic and soft metal tubing.

Control the flow of water in two directions from a single source—these diverting valves have two balls and handles for independent operation of each outlet. Use with fire-fighting hose.

Distribute air or fluid to multiple locations from a single supply source with these manifolds. They are also known as headers.

Valves have NPT connections.

These valves close all ports in the off position to stop equipment in a locked position with air pressure holding it in place. Often used to extend and then retract a cylinder at different speeds, they create two actions and have two exhaust ports, which allows you to control the speed of each action by attaching a flow control valve to each exhaust port. Apply voltage to the electrical connection to actuate.

Mount these filter/regulators to a 35 mm DIN rail with the included brackets.

Use a single air supply to distribute air to up to four locations. In addition to the outlet for inline connection, these manifolds have three 1/4 NPT female outlets for connection to air-powered tools and equipment.

A lower profile than our other compressed air regulators makes these regulators a better fit in tight spots.

Mount these regulators to a 35 mm DIN rail with the included brackets.

Start and stop flow with a quarter turn of the handle. Also known as ball valves.

Turn the handle to direct flow between ports.