For flexible bonds that resist cracking, these adhesives stay pliable.

Moisture, humidity, and immersion in water won't degrade the bond of these adhesives.

For quick repairs, these epoxies begin to harden in 6 minutes or less.

Toughened adhesives are blended with rubber particles for better impact resistance than standard epoxies. They form flexible, resilient bonds.

For invisible bond lines, these adhesives dry clear.

With excellent shear strength, these acrylics form bonds at least 25% stronger than standard acrylic structural adhesives.

No need to mix these acrylics—apply adhesive to one surface and activator to the other, then bring surfaces together to bond.

Acrylics bond to the widest range of materials, especially plastics, and require the least amount of surface preparation.

To keep these adhesives from squeezing out during clamping and give a consistent bond thickness, they're mixed with small glass beads.

Apply this glue like tape for a no-mess alternative to liquid adhesives, hot melts, and staples. Also known as adhesive transfer tape.

Use these glue rolls with 3M dispensing guns.

Spray a thin, uniform coat of adhesive on one or both surfaces, air dry, and then bring together to form strong bonds.

Bonds reach full strength in 10 minutes.

Install vinyl and rubber treads on stairs with this adhesive.

Use these primers with structural epoxies, acrylics, and urethanes to promote bonding to EPDM rubber, polyolefin, and thermoplastic elastomers.

Withstand demanding, high-vibration applications such as motor and pump housings with these threadlockers.

These low-friction threadlockers harden slowly, allowing ample time to smoothly adjust multiple large bolts for even clamping.

These threadlockers develop usable strength within one hour. Because they harden quickly on most metals, they don't require a primer.

Paste threadlockers are easy to apply and won't drip, even from overhead fasteners.

This gel clings to fasteners to prevent drips.

Wrap this no-mess tape around threaded fasteners up to 30 days before installation.

Apply these threadlockers on fasteners that are already installed—their thin consistency allows them to flow into small gaps.

Fill gaps up to 0.01" to secure unthreaded cylindrical metal parts such as shafts, bearings, and press-fit assemblies.

Even on oily surfaces, these retaining compounds keep their hold.

Also known as neutral-cure sealants, these won't discolor copper, brass, and concrete.

Clear enough to read through, these UV-resistant sealants allow optimal light transmission for use with solar cells and fiber optics.

Apply these sealants in cold temperatures, on wet surfaces, and even through running water.

Also known as thumb-grade caulk, this forms a non-hardening, moisture-resistant seal that remains pliable.

These non-sagging sealants will not drip while hardening on vertical and overhead surfaces.

Often used in high-vibration applications that could cause standard thread sealants to fail, these never fully harden and remain pliable enough to self-heal and stop leaks before they start.

Prepare joints and surfaces to ensure proper sealant adhesion.

Prevent the edges of tape, signs, and graphics from peeling by sealing out water and debris.

These non-sagging sealants will not drip while hardening on vertical and overhead surfaces.

These surface fillers come in a pen for precision application. After applying, use the LED on the back of the pen to instantly cure.

Mix these two-part epoxy surface fillers to create a strong repair in wet environments or underwater.

Repair holes and seal gaps in roofing and gutters. These patching compounds are durable and water resistant.

Pour these ready-to-use fillers in cracks up to ½" wide and ¼" deep on horizontal surfaces to make fast, light duty repairs.

These surface fillers come in a pen for precision application. After applying, use the LED on the back of the pen to instantly cure.

These crack fillers come in an easy-to-pour jug for filling cracks in asphalt up to 1/2” wide.