Quickly move parallels in and out of these jaws to raise your workpiece within the vise. Mount jaws to the vise, slide the mating parallels in place, and rest your workpiece on top.

Hardened for wear resistance, these steel jaws are replacements for the ones that come installed on your vise.

Significantly cut down on jaw changeover time—this two-part system lets you swap out jaws in less than 30 seconds. Mount the jaw plates to the vise and slide the dovetailed jaw stock in and out of the plates.

Tilt the head on two axes and rotate the base to position your workpiece at almost any angle.

Keep parts in position for machining by mounting these workstops to your vise jaws.

Mount these workstops into slotted vise jaws—they hold workpieces in place and prevent horizontal movement during machining.

Two vise heads tilt and rotate 360°, locking in place to hold work at any angle.

For large workpieces, these vises open three times as wide as standard tilting-head vises. Tilt and lock the head to position work at an angle.

Replace worn flat and V jaws.

Rotate these vises to solder both the front and back of your circuit board while preventing static charges from damaging your components.

Secure small parts in spring clamps to keep hands free for soldering, gluing, and assembly.