These premium nozzles are engineered for the most efficient airflow consumption.

Also known as air-shield and safety-shield nozzles, a center airstream blows away debris while an outer air curtain deflects flying chips and dust.

Extend these telescoping nozzles to increase your reach.

These needle-style nozzles force air to a precise pinpoint.

These nozzles are made of FDA-listed materials.

Blow air backward to clean out the inside of pipes, tubes, and channels without pushing debris into your system.

The flat nozzle tip distributes air over a wider area than focused airflow nozzles.

Choose a base, hose, and nozzle for a custom setup.

Convert your blowgun to a spray gun. These nozzles spray air and liquids at the same time.

Blow debris and sweep it away with the built-in brush.

The lightweight plastic construction makes these blowguns more comfortable to hold than metal.

Compact enough to carry with you, these guns have a built-in quick-disconnect hose coupling for easy connection to an air line.

Also known as air-shield and safety-shield blowguns, a center airstream blows away debris while an outer air curtain deflects flying chips and dust.

Two inlets allow connection to air lines above or below. Use the top inlet when the blowgun is suspended from an overhead hose and the bottom inlet for bench and floor hoses.

The extra length lets you access hard-to-reach areas.

The lightweight plastic body is more comfortable to hold than metal.

Also known as air-shield and safety-shield blowguns, an outer air curtain deflects flying chips and dust while the center airstream blows away debris.

Increase your reach with the telescoping nozzle.

These blowguns provide more than two times the airflow of standard guns.

Air flows out of the side of the nozzle to clean air filters, radiators, and inside recesses.

The flat nozzle distributes air over a wide area.

Bend the stand's flexible arm to position your gun and keep it in place. Use the included foot pedal to activate airflow and static elimination.

A nonconductive plastic nozzle and tip protect against accidental contact with live electrical circuits. These blowguns are tested to 1,000 volts to meet IEC 60900.

Also known as siphon guns, these spray air and liquids at the same time. Push the lever and the airflow creates suction that draws water, cleaning solution, or other liquids through the hose.

Use one bracket for 3" to 18" wide air knives; two brackets for 24" to 42" wide air knives, and three brackets for 48" wide air knives.

Secure an air knife to the bracket and position where needed. Two swiveling joints allow 360° movement.

Attach to a blower for high-speed airflow at low pressure.

An ionizing bar temporarily neutralizes static to protect against ESD (electrostatic discharge).

Sets include a focused nozzle for concentrated airflow, a flat-tip nozzle for heating wide surfaces, and a deflecting nozzle that protects adjacent surfaces from heating.

Create a wide airflow that’s good for drying and stripping paint.

Insert plastic welding rod through a second opening in the nozzle. It directs air to heat the rod and weld plastic.

The spray is deflected at a steep angle to produce a low-impact, extra-wide spray.

Attach these chucks to your air hose so you can connect the hose to Schrader valves.