Mount using the holes in the base.

Hold a workpiece securely from the side with minimal contact, leaving more of the workpiece free for machining.

Unlike the smooth and flat edges of standard fixture clamps, these clamps have ridges that bite into parts, making them good for gripping castings and rough-cut stock.

Machine these fixture clamps to match the contours of your workpiece for a stronger grip.

Machine these fixture clamps to match the contours of your workpieces for a stronger grip. Place the clamp between the two workpieces in a fixture and tighten the screw to extend the sides of the clamp, creating a secure hold against both workpieces.

Secure a workpiece from the inside, leaving the outside clear for machining.

Instead of a step block, support these clamps using a screw, leveling mount, or any other threaded object.

Eliminating the need for step blocks or other rear support, the pivoting rocker clamps workpieces of various thicknesses.

Good for occasional machining, economy kits contain lower-strength components than standard kits.

The offset shape provides more clearance above the nut than standard clamps. Also known as gooseneck clamps.

Use these blocks to support setup clamps. Fit the nonslip steps together for quick height adjustments.

Keep setup clamps from falling out of position when they are unclamped—the spring holds them up for quick workpiece insertion and removal. Also known as spring lifters.

A plastic pad on the gripping surface of these clamps prevents workpiece marring, making them useful for holding polished surfaces and reducing the need for secondary finishing steps.

The built-in T-slot nut on these side clamps lets you clamp a part to a machine table quickly. Their small footprint leaves more free space on your table than standard side clamps.

Use these clamps to hold large round parts for machining. Each clamp comes with five lengths of chain that combine to accommodate different size workpieces.

Hold magnetic workpieces in place with these clamps.

Each arm has a handle for turning the magnets on and off.

Hold and align up to three workpieces at 90° angles.

Hold workpieces at a 90° angle.

Grip all four corners of a rectangular workpiece.

To grind, drill, lightly mill, and machine parts that rotate around an axis, these chucks hold parts in place magnetically so you can access their inner and outer diameters.

A bright yellow vise body stands out on the shop floor.

Also known as double cams, these complete cam handles have a durable, extra-large handle for clamping on fixture bases, plates, and workpieces. For fast adjustments, push down on the handle and the head applies pressure to quickly draw two parts together.

Use these handles to keep holes aligned or lift several sheets of thin material. They have a plug that expands to grip the edges inside holes. They are not suitable for permanent installation—use only for temporary mounting.