Insert these one-piece grooved liners between vise jaws to hold small-diameter material vertically.

Place over the jaws and tighten the screws to securely attach liners.

Choose from flat and grooved liners.

Rotate the head 360° to use three different vise jaws and lock workpieces in position at 45° intervals.

The head tilts and locks in place to hold work at an angle.

Made of 304 stainless steel to stand up to washdown environments, such as food and beverage production, these are the most corrosion-resistant vises we offer.

Hold tiny workpieces in these compact vises.

The movable jaw can be repositioned to extend the jaw opening. Pull out the entire sliding section and insert it on the opposite side of the vise.

Also known as woodworkers' vises, these mount to the underside of your workbench and sit flush with the surface.

Clamp tubing into these holders to keep it steady while you cut, flare, or expand the end.

The jaws move inward at the same time to consistently position your workpiece in the center of the vise.

Tilt the head on two axes and rotate the base to position your workpiece at almost any angle.

The dials on these vises are graduated in smaller increments than standard cross‐slide drill‐press vises for finer adjustment. Use to precisely position work on X and Y axes.

Push the handle to slide the jaw into place for quicker setup than standard drill-press vises.

Turn the handle to move the jaw on these basic vises.

Use these vises for reliable workholding on CNC machines.

Significantly cut down on jaw changeover time—this two-part system lets you swap out jaws in less than 30 seconds. Mount the jaw plates to the vise and slide the dovetailed jaw stock in and out of the plates.

Hold workpieces steady with these vise jaws—they work with slot-mount workstops so you can quickly position, adjust, and change out your workpieces.

Made from unhardened aluminum or steel, machine these jaws to fit the contours and curves of your workpiece.

The vise body and stationary jaw are one piece for high repeatability, even under heavy clamping loads. Ground flat on the base and three sides, these vises ensure accuracy whether mounted on the base, either side, or upright.

Maintain your vise by replacing seals, springs, and other commonly worn parts.

Mount to a machine table to rotate a vise 360° in 1° increments.

No need to prepare this material before machining parts in dovetail vises—the dovetails and locating slots are already cut in.

Mount these workstops into slotted vise jaws—they hold workpieces in place and prevent horizontal movement during machining.

The entire surface of these plates is magnetic to provide a powerful hold for grinding, drilling, and electrical discharge machining (EDM). Pull the handle to switch the magnets on and off.

Keep clean rooms free of contaminants. These tripod-mounted vises have rubber-covered jaws that prevent metal-to-metal contact and a plastic-encased chain that seals in lubrication.

The jaws are rubber coated to prevent damage to pipe and other round workpieces.

Arrange the pins in a series of holes to grip parts with angled or uneven sides.

Sets include four vises with different opening sizes. A hollow body allows wires and rods to pass through.

Three chuck‐style jaws clamp around your part.

Pass wires and rods through the hollow body of these vises.

Notches on the jaws hold round material on its outside diameter.

Jaw are serrated or grooved to firmly grip workpieces.