Spring-loaded clips create a secure temporary electrical connection for hands-free testing.

Also known as a geophone clip, this clip has rounded jaws that clamp onto battery terminal lugs and other curved surfaces for hands-free testing.

Connect oscilloscopes and other bench-top testers.

Also known as alligator lacing, this strong, impact-resistant lacing uses a staple driver and installation guide to secure staples. Use on 0.0625" to 0.25" thick belts.

This low-profile lacing requires only a hammer to install so it's good for repairs and tight spaces. Also known as alligator lacing, the lacing teeth bite into the belt to hold. Use on belts up to 0.31" thick.

Insert a pin into the lacing and lock it in place by bending the ends at a 90° angle.

More jaw positions than standard adjustable pliers enable fine adjustment and a firm grip. Push and hold the button to adjust the jaws, and then release the button to lock them in place.

Slide the pivot point of the jaws to a range of positions and squeeze the handles to grip.

Move the curved jaws to 15 positions for fine adjustment. These pliers have a bottom jaw that is shorter than the top for a firm grip on the flats of bolt heads and nuts that have rounded corners.

Secure a lanyard to the ring on the handle to prevent dropping your pliers when working at height.

Screw these clips to the wall.

Mount these clips with the adhesive backing, then post paper and notes between the two vinyl-covered magnets.