Metal hose fittings have better durability than plastic barbed hose fittings.

Connect these fittings to air tools for pneumatic applications.

Also known as dry disconnects and double shut-off couplings, these have a shut-off valve in the plug and socket for minimal fluid loss when disconnecting the hose line.

Compatible with Schrader-shape plugs and sockets.

Couplings are metal, which has better durability than plastic cam-and-groove hose couplings. They consist of a plug and a socket that connect and disconnect quickly. Use them if you need frequent access to a line. To connect, insert the plug into the socket and push the levers down.

These nuts attach to high-pressure nipples for compressed gas so you can connect your tank to the inlet of a pressure regulator.

These caps are the fastest way to close off or access your water line. They have a bracket that snaps into any type of 2 1/2 size female fire hose threads. Tap on one of the pin lugs to remove quickly in an emergency.

Offering excellent UV and ozone resistance, this rubber hose is a good fit for outdoor applications.

Hose is made of lightweight, nonmarring PVC.

Twist the barrel to adjust water flow.

Lightweight yet tough, this hose has an abrasion-resistant polyester cover.

Slide the barbed end of these swivels into your dispensing hose and connect with a clamp. They rotate before and after installation as needed to prevent hose from twisting, kinking, and wearing prematurely.

These nozzles let you adjust the flow while dispensing gasoline. They are also known as service-station-style nozzles.

Aluminum fittings have good corrosion resistance, but are lighter in weight than brass.

You don't need a clamp to secure these fittings to tubing. They have a nut on the barbed end that tightens to holds the tubing in place.

Distribute air or fluid to multiple locations from a single supply source with these manifolds. They are also known as headers.

Unlike other manifolds, which have an inlet on either end, these have one inlet on the opposite side from the outlets. This design allows air or fluid to follow a straight path, improving flow through your system. Also known as headers.

Use these manifolds with molding equipment to circulate hot and cold water through your line. They have a red side for hot water and a blue side for cold water.

With outlets on the side instead of on top, these manifolds have a lower profile than rectangular manifolds and fit well in cramped spaces. Use them to distribute air or fluid to three locations from a single supply source.

These durable wash guns are typically used for frequent washdowns and cleanup.

No need for clamps or connectors—duct and fittings have a male end that is slightly smaller than its female end for simple assembly.

Build a custom 1/4" system to deliver coolant, cutting oil, water, or air in any direction.