Known for being one of the easiest types of aluminum to weld, 5052 is also recognized for its ability to resist salt water. It's widely used for the bodies of boats, buses, trucks, and trailers, as well as for chemical drums.

These sheets and bars are tempered to a 1/2-hard or full-hard state to make them over twice as strong as standard 1100 aluminum.

Also known as blue-tempered steel.

Harder than our other 304 stainless steel, these thin sheets offer better wear resistance for use as a wrap, liner, or cover.

The titanium content of 321 stainless steel preserves corrosion resistance around weld points.

Offering high electrical conductivity and formability, 110 copper is 99.9% pure. Also known as ETP copper, it's often used in electrical applications, such as for bus bars and wire connectors, as well as for flashing, gaskets, and rivets.

Use this nickel-iron-cobalt alloy as a magnetic shield to protect electronic equipment from EMI/RFI interference.

Precisely align, level, and adjust spacing on fasteners and shafts with these shims.

Precisely align, level, and adjust spacing on fasteners, shafts, and machinery with these shims, which are color-coded by thickness for easy identification.

Precisely shaped to fit snugly on keyed shafts, these shims align, level, and space components. Because of their tight fit, they also help components rotate in unison with the shaft.

This shim stock is color coded by thickness for easy identification. Cut it into custom shapes to fit your application.

These shims are color-coded by thickness for easy identification. The slot lets you insert, remove, and adjust the shims without disassembling your machinery.

Use this film on metal and plastic parts, appliances, and electronic equipment for protection against damage during packaging, shipping, and installation.

Also known as nylon 6/6, this general purpose material is often used for bearings, gears, valve seats, and other high-wear parts.

An aluminum coating on one side of this film reflects heat, so it’s widely used as an insulator and in packaging applications.

Not only does PEEK provide superior wear resistance in repetitive processes, it is also resists wear caused by abrasion. PEEK can be used as a lightweight substitute for metal parts in chemical-processing applications.

Because this film dissipates heat, it is often used for printed circuit boards and power supplies.

The slippery surface on this FEP film prevents sticking. Use it as a release film when making molded parts.

Polyester absorbs almost no moisture and resists swelling in wet environments. It is also known as PET and PETE.

Gauges are 12” long and have finished ends marked with thickness.

Use these feeler gauge assortments to check gaps, alignment, and narrow slots.

To keep the set complete, gauge leaves are riveted together in a fan design that folds up for portability.

To ensure accurate readings, these sets come with a certificate of calibration traceable to NIST that states they’ve passed a test for accuracy.

Leaves have narrow ends to measure thickness where standard feeler gauges can’t fit.

Run these sheets of labels through any standard laser or inkjet printer.

Write on these labels to mark equipment with a company name and address or ID number.

Good for larger signs, peel off the backing and apply these to one or both sides of your sign.

Also known as newsprint, this paper is a clean, low-cost fill material.

Apply this glue like tape for a no-mess alternative to liquid adhesives, hot melts, and staples. Also known as adhesive transfer tape.

This silicone glue withstands temperatures up to 500° F.