The anodized coating on these lightweight spacers provides increased abrasion resistance over uncoated aluminum.

Cut stock to the length you need.

Use these metric washers to evenly distribute the load under bolt or screw heads and nuts when fastening. They can also act as spacers.

Choose these washers for their adherence to strict military standards for material and construction.

Also known as backup washers, these are for use with blind rivets for extra support when fastening into soft material.

As a screw is tightened, these washers flatten to add tension to the joint and prevent loosening from small amounts of vibration.

Also known as crush washers, these compress when tightened to form a tighter, more durable seal than rubber washers. They are commonly used to seal fluids such as oil and fuel.

In addition to joining male- and female-threaded parts, these adapters can increase or decrease metric thread sizes and change the thread pitch.

Need to join two female-threaded parts, such as coupling nuts, with dissimilar inch thread sizes? Attach them to these adapters and tighten the exterior hex nut for a secure connection.

One side inch, one side metric, and a hex in the middle—these handy fasteners connect two female-threaded parts, such as coupling nuts, adapting from inch threads to metric. Tighten with a standard wrench.

These shims are made of layers of metal bonded with adhesive. Remove layers with a utility knife until you get the thickness you need.

These shims are color-coded by thickness for easy identification. The slot lets you insert, remove, and adjust the shims without disassembling your machinery.

Keep shim stock in a variety of thicknesses on hand with these sets. Cut into custom shapes to fit your application.

This shim stock is color coded by thickness for easy identification. Cut it into custom shapes to fit your application.

Cut this shim stock into custom shapes to fit your application. Stock is made of layers of material bonded with adhesive; remove layers with a utility knife until you get the thickness you need.

Send us a drawing, and we'll cut your custom shim. Shims are made of layers of metal bonded with adhesive; remove layers with a utility knife until you get the thickness you need.

An aluminum shell adds strength.

Installing and removing a collar is as easy as pushing down and lifting up a clamp lever.

Wider than standard shaft collars with twice the number of clamping screws, these ensure a better grip for greater holding power.

These metal collars are stronger than plastic shaft collars.

Make quick adjustments to these shaft collars with a lever on the side.

Although these collars fit inch-sized shafts, they have a metric OD and width for use with metric equipment.

Secure items to either side of these collars—each half has a flat end with a tapped hole

Attach items to tapped holes at either end of these collars and twist the lever to quickly move them along shafts.

To install, slide these one-piece collars onto the end of your shaft.

Ridges on the inside of these bearings wipe away dust and debris as the bearing travels on a shaft.

A ceramic coating makes high speeds as well as rapid acceleration and deceleration possible.

Sleeve bearings outperform ball bearings in dirty environments. Use them for low speed applications.