Use these fittings for low-pressure applications in noncorrosive environments.

The galvanized finish on these fittings provides fair corrosion resistance. Fittings are for use in low-pressure applications.

These fittings can stand up to high-pressure applications. Use them in noncorrosive environments.

Use these corrosion-resistant fittings in a low-pressure pipe line.

Use these heavy duty, corrosion-resistant fittings in high-pressure flow applications.

Not only do these brass fittings have the strength to handle high-pressure applications, the male threads have a sealant applied for extra protection against leaks.

The male threads on these brass fittings have a sealant applied for extra protection against leaks. Also known as Pressure Class 125 fittings, they are built for use in low-pressure applications.

Extreme pressures are no problem for these heavy-duty brass fittings.

Designed for medium-pressure applications, these fittings have better strength than our low-pressure aluminum pipe fittings.

Also known as Schedule 40 fittings, these have thicker walls than our thin-wall aluminum unthreaded pipe fittings.

Titanium has similar strength to steel, but is approximately 40% lighter. It has better corrosion resistance than most stainless steel alloys and can handle corrosive substances, such as salt water and acids.

These Schedule 40 fittings are the industry standard for gravity-flow drain, waste, and vent (DWV) applications.

Also known as dry disconnects and double shut-off couplings, these have a shut-off valve in the plug and socket for minimal fluid loss when disconnecting the hose line.

Use these couplings at pressures up to 6,500 psi. They consist of a plug and socket that connect and disconnect quickly. Use them if you need frequent access to a line. They are compatible with Snap-Tite H-Shape plugs and sockets.

Protect mini connectors when not in use.

Often used in offices and workstations, these outlet strips power multiple devices from a single wall outlet.

The power switch to these outlet strips is on a 44" long cord, so you can control power even when the strips are in hard to reach places, such as under a desk.

Install these extra-long strips onto the frame of an electrical cabinet.

Save time when wiring connections in a junction box; these blocks come already installed in an enclosure.

These plugs withstand temperatures up to 600° F to protect internally threaded NPT connections from contaminants during electropainting, paint baking, and powder coating applications.

Designed to fit into 37° flared connections such as those found on JIC and SAE fittings, these plugs protect internally threaded connections from contaminants during fabrication and storage.

More durable than plastic caps, these provide the most protection from abrasion and impact.

Give open-ended standoffs a finished look and protect them from dirt and debris.

Half the weight of steel, this aluminum framing resists corrosion in wet environments.

Give switches and outlets a finished look.

Mount these boxes to the outside of an enclosure to access a programmable logic controller or other networked device without opening the enclosure.

Stop cords from coming loose in wet environments while keeping them along the side of your enclosure in tight spaces.

Create a tight grip on cords in wet environments while reducing stress from bending—the 90° angle of these cord grips routes cords to fit tight spaces in enclosures and panels.

Keep your cord at a gentle angle without sacrificing a tight hold, even in tough, wet environments.

These cord grips are lightweight yet durable.

The mesh extension provides a secure hold in applications where cable is pulled or in motion. It reduces stress on the cable and prevents kinking for longer cable life.

These cord grips are lightweight yet durable. They have a zinc-plated steel locknut and metal-reinforced rubber O-ring that prevents liquid from entering the connection.

Secure cords in wet and industrial environments with little room—these grips curve 45° to relieve bending stress.

These 90° elbows meet Class III, Divisions 1 and 2 standards for use in hazardous locations.

Mount these sights from the inside of your tank and secure with a lock nut.