When concrete is saturated with or submerged in water, use these epoxies to permanently set threaded rods, studs, and rebar. They form a weather-resistant chemical bond that seals out moisture and resists vibration and dynamic loads better than mechanical anchors. Warning: Allowable pull-out strength is 25% of ultimate values or less, as required by building authorities. Use a mixer nozzle and dispensing gun (dispensing gun sold separately) to simultaneously mix and dispense adhesive.

Permanently set threaded rods, studs, and rebar in concrete with these kits. They include applicators and mixer nozzles to simultaneously mix and dispense the adhesive. These adhesives form a weather-resistant chemical bond that seals out moisture and resists vibration and dynamic loads better than mechanical anchors. Warning: Allowable pull-out strength is 25% of ultimate values or less, as required by building authorities.

Bond new concrete to old concrete, or use this epoxy as a primer for epoxy coatings on concrete surfaces. Mix the amount you need; the size listed is the combined total of the two parts.

These adhesives maintain their strength in temperatures up to 250° F. Use them to permanently set threaded rods, studs, and rebar in concrete. They form a weather-resistant chemical bond that seals out moisture and resists vibration and dynamic loads better than mechanical anchors. Warning: Allowable pull-out strength is 25% of ultimate values or less, as required by building authorities.

Use the included mixer nozzle and a dispensing gun (sold separately) to simultaneously mix and dispense adhesive.