These steel anchors are available with corrosion-resistant finishes.

More corrosion resistant than 18-8 stainless steel anchors, these 316 stainless steel anchors have excellent resistance to chemicals and salt water.

A zinc plating provides corrosion resistance in wet environments.

A zinc plating provides corrosion resistance in wet environments.

More corrosion resistant than 18-8 stainless steel anchors, these 316 stainless steel anchors have excellent resistance to chemicals and salt water.

A zinc plating provides corrosion resistance in wet environments.

Install like a stud anchor—just thread the anchor, a nut, and a washer onto the end of a threaded rod, drive into a hole, and turn the nut to expand the base. Also known as rod anchors, they're often used with threaded rod to hang pipe and wiring.

Drive these tools with a hammer to expand anchors.

Also known as double expansion anchors, these expand from both sides for full contact and a secure hold.

Bolts are beveled under the head for a flush finish in countersunk holes.

A pivoting toggle bar creates a strong hold.

18-8 stainless steel anchors have good chemical resistance.

18-8 stainless steel anchors have good chemical resistance.

A spring-loaded toggle holds against the back of the material.

You can use these versatile hangers in a threaded hole (as you would a screw), or secure them with a nut (as you would a bolt).

18-8 stainless steel studs have good chemical resistance and may be mildly magnetic. Also known as hanger bolts, use them to hang, mount, and fasten parts to wood structures.

These clamps rotate 360° and pivot 45° to ensure the rod hangs straight, even on sloped beams.

For centered load distribution, these clamps grip both sides of the beam and hang threaded rod from the middle.

Install directly into a mounting surface to suspend threaded rod from ceilings and walls.

Add an eye nut to threaded rod to hang the rod from rings, hooks, and hangers.

Load material between the two halves of the ring and adjust the side bolts for a tighter fit than standard threaded-rod-mount clamping hangers.

Also known as clevis hangers, these have a pivoting loop that adjusts for line movement and vibration. Combine with a threaded rod or other fastener to hang from the ceiling.

A roller on the bottom of these hangers compensates for movement due to expansion and contraction, such as in hydraulic applications. Combine with a threaded rod or other fastener to hang from the ceiling.

Use these hangers in corrosive environments and where chemicals are present. They're also known as teardrop hangers. Combine with a threaded rod or other fastener to hang from the ceiling.

A mounting plate provides a more secure hold at the mounting surface.

Suspend and route flat-bottomed objects such as strut channel and small duct.

Reduce vibration and prevent metal-to-metal corrosion on flat-bottomed objects such as strut channel and small duct.

A durable rubber cushion and mounting plate prevent corrosion and wear caused by metal-to-metal contact. The mounting plate is removable, so the U-bolts can be installed onto an existing line without needing to dissemble it.

Support lines that expand and contract. The roller on these supports compensates for movement in your line from changing temperatures.

Install these stud-end plug-lock fittings on the end of wire rope for a strong hold and finished appearance.