Hold workpieces at a 90° angle.

Position workpieces at any angle from 0° to 180°.

Hold the workpiece down against a bench or table.

Hold magnetic workpieces in place with these clamps.

Each arm has a handle for turning the magnets on and off.

For repetitive clamping, turn the holding screw to adjust the opening size one time, and then use the handle to secure and release workpieces.

Clamp workpieces from the outside at a 90° angle, leaving the inside free for welding or fabrication.

Each jaw can be positioned at an angle to hold round, angled, and odd-shaped material.

Push the lever to lock the handle and prevent accidental opening.

An easy-to-tighten band encircles and holds round and odd-shaped objects with even pressure.

Slide the upper jaw to adjust the opening size. These clamps hold larger workpieces than other locking plier clamps of similar size.