Quickly move parallels in and out of these jaws and raise your workpiece within the vise. Choose jaws and the mating pair or set of parallels. Mount jaws to the vise, slide the parallels in place, and then rest your workpiece on top to allow more clearance for cutting tools.

Arrange the included pins in a series of holes to position a part at any angle and hold odd-shaped parts securely.

Significantly cut down on jaw changeover time—this two-part system lets you swap out jaws in less than 30 seconds. Mount the jaw plates to the vise and slide the dovetailed jaw stock in and out of the plates.

Jaw plates have set screws on top for securing the jaw stock. Tighten using the included T-handle key. Plates have an industry standard hole pattern that fits most manufacturers' vises, including Kurt, Chick, TE-CO, Toolex, and Palmgren.

31" wide machinable jaw stock can be cut to length. It can also be secured across multiple vises for machining long parts.

The V-shaped recess holds round material securely for machining. Place one of these jaws on one side of your vise and use a flat jaw on the other. They have an industry standard hole pattern that fits most manufacturers' vises, including Kurt, Chick, TE-CO, Toolex, and Palmgren.

Jaws with vertical groove holds 3/4" to 1 3/4" dia. workpieces.

Jaws with vertical and horizontal grooves holds 1/2" to 1 1/4" dia. workpieces vertically and 1/4" to 1/2" dia. workpieces horizontally.

Hold workpieces steady with these vise jaws—they work with slot-mount workstops so you can quickly position, adjust, and change out your workpieces. Using jaws and workstops together keeps the workpiece from slipping, and gives you more control over the position than jaws alone. Slide your workstop into a slot on either the top or the bottom jaw and tighten with a screw. One slot is closer to the jaw face than the other to give you more positioning options. These jaws have industry-standard mounting hole patterns to match most vises, including those made by Kurt, Chick, TE-CO, Toolex, and Palmgren.

For technical drawings and 3-D models, click on a part number.

The vise body and stationary jaw are one piece for a repeatable clamping accuracy of ±0.0005", even under heavy loads. Ground flat to a parallel tolerance of 0.0005" on the base and three sides, these vises ensure accuracy whether mounted on the base, either side, or upright. They are designed for use with 3- and 4-axis CNC milling machines. To hold wider workpieces, you can attach the jaws to the outside ends of the jaw plates.

For technical drawings and 3-D models, click on a part number.

Replace worn, broken, or lost handles.

Pivoting handles let you tilt the handle out of the way.

Three-spoke handles spin freely to open and close vise jaws quickly.