For applications that require intermittent operation, such as spraying and washing, push or pull the lever on these valves to start flow. They spring closed when the lever is released.

Push a button or flip a toggle switch to start or stop flow.

Control flow in passageways of manifolds and valve mounting blocks without external pipes. Also known as cartridge valves, they slide into unthreaded holes and secure in place with the included set screw.

Start or stop flow with the flip of a toggle switch or the push of a button. They fit through a cutout, so the body of the valve stays safe inside your instrumentation panel.

Insert tubing into the fittings on these valves—no heat, solder, or flux required.

For easy installation from any direction, the body on these valves swivels 360°. They have barbs to securely grip tubing.

Easily access the handle of these valves while protecting your line behind an instrument panel. They have threads and a hex nut below the handle for panel mounting. For extra gripping power and a strong seal, they have Yor-Lok fittings with two sleeves that bite into tubing as you tighten the nut. They’re compatible with Swagelok®, Let-Lok, and Parker A-Lok fittings.

Insert your tubing into the fittings of these valves with just a push—the internal rings will grip it tight. Made of plastic, these valves are a lightweight alternative to metal valves. All meet NSF/ANSI 61 for safe use with drinking water.

Barbs grip onto tubing to give these valves a secure hold. These valves meet NSF/ANSI 61, so they’re safe to use with drinking water.

Insert tubing into the fittings on these valves—no heat, solder, or flux required. To withstand aggressive and corrosive solutions, they have a chemical-resistant fluoroelastomer seal and a plastic body.

Push tubing into the fittings on these valves and an internal gripping ring and O-ring hold it tight—no heat, solder, or flux required. They meet either NSF/ANSI standards or are FDA compliant for use with food.

Also known as saddle valves and humidifier valve clamps, these self-piercing valves allow you to tap existing copper tubing lines to redirect a small amount of liquid for on/off control of a secondary line.

Empty fluid from tanks in boiler rooms or heat transfer systems—these valves withstand higher temperatures than our other drain valves. Also known as stop cocks.

Often used in tight spaces, these valves shut off water with a quarter turn of the handle.

Keep fluids flowing—these valves twist and turn to prevent your hose from kinking.

Also known as solenoid valves, these valves are operated by an electrical signal to turn airflow on or off.

Protect air-powered equipment in emergency shut-off situations—when system pressure drops, these valves automatically close to stop cylinder motion, even at mid-stroke. They control the speed of air-powered equipment by adjusting the volume of airflow entering or exiting.