Also known as diagonal-cutting pliers.

Leverage points in both the jaws and the handle give you more power with less effort.

These cutters are stainless steel, which provides excellent corrosion resistance.

The specially designed internal spring provides constant, uniform tension for superior performance.

The grips on these cutters drain static from your application, preventing buildup from electrostatic discharge (ESD).

Make accurate cuts at precise angles. These cutters have a miter guide that is notched to line up your workpiece.

Prevent waste from flying up as you work. A double blade makes two cuts to create a 7/64"-wide step that peels back, leaving little distortion and smooth edges.

Keep your hand away from the material being cut.

Blades are high-speed steel so they stay sharp longer than steel blades, and they can be sharpened.

These cutters make straight cuts and curves.

Also known as bulldog snips, these durable cutters have long handles and short blades for cutting heavy material in any direction.

Blades are tapered to give you more control when cutting straight lines, tight curves, and circles, and they're serrated to prevent slipping. These cutters are also known as duckbill snips.

Also known as slotting shears, these cutters have a double blade that creates two cuts and a 7/32" wide waste strip that peels back, leaving two smooth edges with little distortion.

Use to cut patterns in flat material with minimal material loss and less effort compared to manual cutters.

Make a flush cut that leaves a smooth, finished edge.

Turn your workpiece while cutting to create curves and complex shapes.

Prevent chipping, binding, and fracturing when cutting brittle, high-pressure laminated plastic.

Cut thin, hard wire with these small cutters.

Made of solid carbide, these end mills are harder, stronger, and more wear resistant than high-speed steel and cobalt steel for the longest life and best finish on hard material. Their angled profile allows chamfer, bevel, and other angled cuts.

Use these end mills for general purpose work in most material, such as aluminum, brass, bronze, iron, and steel. The teeth are angled on both sides so you can make top and bottom chamfer cuts without having to flip the workpiece.

Made of solid carbide, these end mills are harder, stronger, and more wear resistant than high-speed steel and cobalt steel for the longest life and best finish on hard material. The teeth are angled on both sides so you can make top and bottom chamfer cuts without having to flip the workpiece.

Extra-long handles enable access to hard-to-reach areas. Also known as lineman’s and combination pliers, use these tools to pull, bend, and cut wire.

Also known as lineman’s and combination pliers, use these tools to pull, bend, and cut wire.

Additional features, such as wire terminal crimpers, enable you to perform a variety of electrical wiring and installation work with a single tool. Also known as lineman’s pliers, use them to pull, bend, and cut wire.

Insulated grips protect against accidental contact with live electrical circuits. These pliers are tested to 1,000 volts to meet IEC 60900 and ASTM F1505. Use them to pull, bend, and cut wire.

Made of aluminum-bronze that is FM approved, these pliers satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present. Use them to pull, bend, and cut wire.