From cookware to chemical-processing equipment, 304 stainless steel is a good all-around choice for a wide range of applications.

This material has tighter tolerances than standard 304 stainless steel.

When compared to standard 304 stainless steel, this material can be machined faster with less wear on cutting tools. It's also called Prodec and Project 70+.

Compare the appearance choices of our 304 stainless steel with these convenient selector packs.

A traceable lot number and test report is furnished with each piece.

This material has tighter tolerances than standard 303 stainless steel.

When bent, this wire will stay in place. It's widely used as tying and locking wire.

Offering outstanding resistance to surface wear and corrosion, Nitronic 60 stainless steel is often used for shafts, fasteners, and valves.

The addition of molybdenum gives 316 stainless steel excellent corrosion resistance. Use it in a variety of marine and chemical-processing applications.

Bend this wire and it will stay in place. It's widely used as tying and locking wire.

These selector packs contain one 1-3/4"×3"×1/16" thick piece of 316 stainless steel in the following finishes: brushed #4, mirror-like #8, and unpolished.

This material machines faster with less wear on cutting tools than standard 316 stainless steel. It's also called Prodec and Project 70+.

2205 stainless steel resists cracking even when faced with a combination of tensile stress, corrosive chemicals, and heat. Also known as duplex stainless steel, it has twice the strength of 316 stainless steel. Use it for high-pressure applications in caustic environments.

Also called flat stock, these precision-ground bars are held to tight thickness and width tolerances.

Suitable for making molds, 420 stainless steel is a hard, wear-resistant material that can be finely polished to a very smooth surface.

One of the hardest types of stainless steel after heat treating, 440C offers excellent wear and abrasion resistance. It's often used for bearings, valves, and knife blades.

Ready for turning in your lathe, these rods are precision ground to a tight tolerance.

Often used for fasteners and valves, 410 stainless steel withstands wear caused by abrasion.

Bend this wire and it will stay in place. It's commonly used as tying and locking wire.

With excellent strength and wear resistance, S30V stainless steel is a preferred material for knives and cutlery.

With a higher chromium content than 15-5 PH stainless steel, this high-strength 17-4 PH offers better corrosion resistance. It is also known as 630 stainless steel.

Also known as Project 70+, this material machines faster with less wear on cutting tools than standard 17-4 PH stainless steel.

These precision-ground rods are ready for turning in a lathe. They're furnished with a traceable lot number and test report.

Offering outstanding strength, 15-5 PH stainless steel is often used for gears and shafts.