Choose a Category
    Clear All
    System of Measurement
    System of Measurement
    Inch
    For Holding
    For Holding
    Collets
    End Mills
    For Use With
    For Use With
    Milling Machines
    Material
    Material
    Steel
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Shank Type
    Shank Type
    Show
    CAT 40 Taper
    For Collet Type
    For Collet Type
    ER-16
    ER-20
    ER-32
    ER-11
    ER-25
    100-TG
    For End Mill Shank Diameter
    For End Mill Shank Diameter
    1/8"
    3/16"
    1/4"
    3/8"
    1/2"
    5/8"
    3/4"
    1"
    1 1/4"
    Head Length
    Head Length
    2 3/8"
    2 1/2"
    3"
    4"
    For Number of End Mill Milling Ends
    For Number of End
    Mill Milling Ends
    1
    2
    Shank Thread Size
    Shank Thread Size
    5/8"-11
    Collar Diameter
    Collar Diameter
    0.512"
    0.641"
    Flange Thickness
    Flange Thickness
    0.12"
    0.24"
    0.28"
    Grip Angle
    Grip Angle
    15°
    30°
    45°
    90°
    Head-to-Flange Length
    Head-to-Flange Length
    0.433"
    0.44"
    0.793"
    0.99"
    Manufacturer
    Manufacturer
    Lyndex Nikken
    Maximum Torque
    Maximum Torque
    59 ft.-lbs.
    Not Rated
    Minimum Torque
    Minimum Torque
    44 ft.-lbs.
    Not Rated
    Specifications Met
    Specifications Met
    click to learn more about
    Thread Size
    Thread Size
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    56 Products