Choose a Category
    Clear All
    System of Measurement
    System of Measurement
    Inch
    For Arbor Hole Size
    For Arbor Hole Size
    1/2"
    5/8"
    3/4"
    7/8"
    1"
    1 1/4"
    1 1/2''
    For Use With
    For Use With
    Milling Machines
    Overall Length
    Overall Length
    2 1/2"
    3"
    5 3/32"
    Material
    Material
    Steel
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Shank Type
    Shank Type
    Show
    R8 Taper
    Nose Diameter
    Nose Diameter
    1/2"
    3/4"
    1"
    1 1/4"
    1 1/2"
    Shank Thread Size
    Shank Thread Size
    7/16"-20
    For Arbor Hole
    For Arbor Hole
    Unthreaded
    For End Mill Shank Diameter
    For End Mill Shank Diameter
    1/8"
    3/16"
    1/4"
    5/16"
    3/8"
    1/2"
    5/8"
    3/4"
    7/8"
    1"
    1 1/4"
    1 1/2"
    Nose Length
    Nose Length
    9/16"
    19/32"
    11/16"
    23/32"
    1"
    For Keyway Width
    For Keyway Width
    1/4"
    5/16"
    3/8"
    1/2"
    5/8"
    For Maximum Cutter Diameter
    For Maximum
    Cutter Diameter
    4"
    For Collet Type
    For Collet Type
    ER-16
    ER-20
    ER-32
    Mount Type
    Mount Type
    Arbor
    For Maximum Cutter Thickness
    For Maximum
    Cutter Thickness
    3/16"
    For Number of End Mill Milling Ends
    For Number of End
    Mill Milling Ends
    1
    2
    For Tool Morse Taper Number
    For Tool Morse
    Taper Number
    2
    3
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    59 Products