McMaster-Carr logo
    Clear All
    System of Measurement
    System of Measurement
    Inch
    Thread Size
    Thread Size
    click to learn more about
    Head Type
    Head Type
    Hex
    Threading
    Threading
    Partially
    Threaded
    Head Width
    Head Width
    default
    7/16"
    1/2"
    9/16"
    3/4"
    Head Height
    Head Height
    default
    11/64"
    13/64"
    15/64"
    19/64"
    Material
    Material
    Steel
    Finish
    Finish
    Cadmium Plated
    Drive Style
    Drive Style
    click to learn more about
    Minimum Thread Length
    Minimum Thread Length
    15/32"
    17/32"
    41/64"
    25/32"
    Thread Fit
    Thread Fit
    click to learn more about
    Thread Direction
    Thread Direction
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    click to learn more about
    Thread Type
    Thread Type
    Tensile Strength
    Tensile Strength
    click to learn more about
    100,000 psi or greater
    Hardness
    Hardness
    Rockwell C26
    Thread Spacing
    Thread Spacing
    click to learn more about
    Locking Type
    Locking Type
    Cotter Pin
    Hole Center-to-Grip Length
    Hole Center-to-Grip Length
    0.313"
    0.359"
    0.438"
    0.609"
    Hole Diameter
    Hole Diameter
    0.076"
    0.106"
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    58 Products