Made of stainless steel, these carriages and guide rails are more corrosion resistant than steel carriages and guide rails.

Suitable for clean room use, these carriages and guide rails are made entirely of stainless steel.

These carriages and guide rails are steel.

Designed for use on horizontal surfaces, the contact angle of the ball bearings on the rail allows these carriages to last longer than other carriages.

Mount to vertical surfaces for applications where tight tolerances aren't required.

With a wide base and low-profile design, these carriages and guide rails stabilize moment (twisting) and off-center loads better than other carriages and rails. They're good for use in areas where multiple carriages or rails won't fit.

Mount along a wall or other vertical surface.

These track roller carriages and guide rails are stainless steel for use in wet, corrosive environments.

Needle-roller bearings give these track roller carriages higher load capacities than other track roller carriages.

High-temperature PTFE-thickened grease enables these carriages to operate in temperatures up to 500° F, higher than any other carriage that we offer.

With a row of crossed-roller bearings on each side of the rail, these slides have over twice the load capacity of standard low-friction slides and are better for handling shock loads.

Create your own positioning table or telescoping slide. Sets include four rails, two roller bearing cages, and eight end stops.

A thumb screw locks the slide to prevent movement in systems where vibration is present.

Two micrometer handles ensure accurate, repeatable positioning along two axes—good for positioning parts, such as measuring and inspecting equipment, that are part of a larger automated system.

Position shafts an inch or two off the ground to maintain bearing and part clearance. Support rails provide stability over the entire length of shaft, allowing virtually unlimited travel lengths and eliminating bending under moderate to heavy loads.

At approximately one-third the height of standard versions, these rails provide linear shaft support in applications with low vertical clearance. They provide stability over the entire length of shaft, allow virtually unlimited travel lengths, and eliminate bending under moderate to heavy loads.

With 2" of each end softened, it's easier to machine a custom end for mounting. The rest of the shaft is case-hardened, which increases hardness and wear resistance on the surface of the shaft while allowing the center to remain soft for absorbing stresses caused by shifting loads.

Clip retaining rings into the grooves to separate and position collars, supports, and housings.

Keep a material certificate on hand for compliance and quality assurance needs. Certificates include a traceable lot number and material test report. These hollow shafts reduce system weight and allow you to run various media such as electrical wiring, compressed air tubing, coolants, or lubricants through the center.

A shoulder near the end of the shaft allows for easy positioning of housings, shaft supports, and collars.

These two-piece supports allow access to the shaft without needing to slide out the shaft or uninstall the support. Use them to brace the end of a linear shaft when working with light to medium loads where shaft alignment is not critical. Tighten the included clamping screws to secure.

These shaft supports hold linear shafts perpendicular to the mounting surface.

The stacked design provides stability for deep and wide drawers.

Slides only extend 3/4 of the closed length to reduce the chance that a heavy load will tip your cabinet.

Open drawers from either side of a cart or cabinet—these slides let drawers pass through for two-way access to contents.

A stop holds the drawer open; push firmly on the drawer to close.

Slides only extend 3/4 of the closed length to reduce the chance that a heavy load will tip your cabinet.

These slides automatically pull the drawer closed when it approaches the closed position.

When you don't have enough clearance for side-mount or under-the-counter slides, mount these to the base of your drawer.

Mounting to the tops and bottoms of drawers, these steel slides support drawers even if they’re tall and hold heavy equipment.