Half the length of other drawer slides we sell, these slides install in small-parts cabinets.

Slides only extend 3/4 of the closed length to reduce the chance that a heavy load will tip your cabinet.

These slides automatically pull the drawer closed when it approaches the closed position.

Open drawers from either side of a cart or cabinet—these slides let drawers pass through for two-way access to contents.

These slides provide full extension for convenient access to the back of your drawers.

A stop holds the drawer open; push firmly on the drawer to close.

To prevent drawers from slamming shut and support them even if they’re tall and full of heavy equipment, these steel slides have soft-closing bumpers and mount to the top and bottom of drawers.

A stop holds the drawer closed; pull firmly on the drawer to open.

Made of stainless steel, these carriages and guide rails are more corrosion resistant than steel carriages and guide rails.

Made of stainless steel, these carriages and guide rails are more corrosion resistant than steel carriages and guide rails.

Suitable for clean room use, these carriages and guide rails are made entirely of stainless steel.

A plastic cage surrounds the ball bearings and keeps them from colliding, so these carriages run for many cycles without needing maintenance.

Run many cycles in tight spaces before replacing or re-greasing carriages.

Mount to vertical surfaces for applications where tight tolerances aren't required.

These track roller carriages and guide rails are stainless steel for use in wet, corrosive environments.

Use these carriages and guide rails for light loads where precise movement is not required.

Nylon rollers provide low-friction movement for light loads and corrosive environments.

Good for use in pick-and-place applications, machine tool doors, and telescopic press arms, these rugged slides are designed to carry heavy loads.

Two micrometer handles ensure accurate, repeatable positioning along two axes—good for positioning parts, such as measuring and inspecting equipment, that are part of a larger automated system.

A thumb screw locks the slide to prevent movement in systems where vibration is present.

Designed to handle heavy loads, these bearings have the highest load capacities of any mounted linear ball bearings we offer.

Use the adjustment screw in the housing to tighten or loosen the snugness (also known as preload) of the bearing to your shaft.

The flanged housing makes these bearings a good solution for vertical linear motion applications.

Outdoor as well as mild chemical environments are no problem for these bearings. They have stainless steel balls for corrosion resistance.

Ready to mount on your linear motion spline shaft, these bearings come installed in a housing and have grooves that match up with the splines on your shaft.