Made of silver-plated 321 stainless steel, these O-rings can handle extreme pressure up to 11,000 psi. They resist grease, hydraulic oils, mineral oil, motor oil, and synthetic lubricants.

Easy to use, strong, and versatile, these hose clamps are the most common. Tighten their slotted screw with a screwdriver, hex nut driver, or wrench.

A raised safety collar around the head of the screw prevents your screwdriver from slipping and damaging the hose or tube.

One clamp fits a wide range of diameters, so you can always have the right size on hand.

These clamps are easier to install than our Extra-Strength Low-Profile Band Clamps. Also known as center-punch clamps, they seal with a quick hammer blow to the buckle.

Designed for both permanent connections and emergency repairs, use these buckles with banding to create your own low-profile hose clamps.

These clamps form a 360° seal around your hose or tube to prevent leaks.

Not as bulky as our other constant-tension clamps, these round-wire clamps easily fit in cramped spaces. Use in low-pressure applications.

Clamps have a slotted hex-head screw that flips up to release the band for quick opening.

Unlike other pinch clamps, these have a unique tongue-and-groove design that creates a gap-free seal to reduce leaks.

These pinch clamps come packed in a box with individual compartments for each clamp size. Easier to install than worm-drive clamps, crimp the pinch points with pinch-clamp pincers for a secure hold. They’re commonly known as ear clamps.

To prevent removal, these clamps can only be loosened with a special bit or screwdriver.

Unlike other duct hose clamps, these are rated for a maximum work load. Clamps have a quick-release latch that lets you access your line frequently while maintaining your original clamp size.

Clamps have a smooth band with rolled edges to prevent them from cutting into your hose or tube.

Create 4" diameter and larger worm-drive clamps that withstand high-temperature applications.

An extended tail acts as a liner to protect hose and tube from being cut by the slots in the band.

Flip up the slotted hex head screw to quickly release the band. These clamps have rounded edges and a smooth interior, so they won’t cut into hose and tube materials.

The hose clamps in these assortments have a bolt closure that creates a 360° leak-preventing seal. The clamps have rolled edges, so they won’t cut into hose and tube.

Woven from flexible stainless steel yarn and Nomex, these ties handle temperatures up to 850° F.

The ripple in the body prevents over tightening and allows for expansion to protect material that frequently changes size, such as heat cable.

The rounded, low-profile head keeps these ties from snagging and allows them to fit in tight spaces. Made of stainless steel, all of these ties stand up to chemicals.

Use these mounts with stainless steel cable ties when working in corrosive environments.

Attach these hooks to elastic cord to make a tie down.

The base of these hooks grip rope.

This metal strapping is the standard for packaging and shipping applications.

With ends that are connected to form a circle, these garter springs exert strong radial (towards the center) forces from all directions to maintain pressure on shafts or in seals.

Clip the end onto a flat surface to install—no fasteners needed. Once installed, these springs pull back with the same amount of force no matter how far you extend them.