Mount components to these load-rated bearings and track rollers to add linear motion along T-slotted rails.

Screw and nut sets or nuts secure brackets and other accessories to rails.

Attach and position phones, tablets, monitors, and other displays on T-slotted rails.

Seal T-slots, rail ends, and gaps between rails to keep out dust, debris, and other contaminants.

Route wires, cables, and tubing along T‐slotted rails.

Made of yellow zinc-plated steel, these metric leveling mounts are more corrosion resistant than nickel-plated steel leveling mounts.

Made of 303 stainless steel, these metric mounts resist corrosion from water and most chemicals.

Punch-out holes in the base let you bolt down these metric mounts to keep your equipment stationary.

Use these metric mounts on heavy machines and equipment.

Made entirely of plastic, these mounts are resistant to oil and won't scratch your mounting surface.

Designed for use in sanitary and food processing areas, these mounts level tanks and machinery on uneven floors and create space to clean underneath.

An interlocking steel frame in these mounts prevents collapse, even if the rubber fails.

All-stainless steel construction stands up to water and chemicals and won't rust or corrode.

Thread these mounts into machinery to level them on uneven floors in sanitary environments such as food-processing areas.

Designed to slide into T-slot tracks on machine tool tables, use these nuts to secure clamps and workpieces.

Install from the top of the T-slot track and secure with a quarter turn. Also known as quarter-turn T-slot nuts.

Prevent chips, debris, and small parts from falling into T-slots.

Install spring plungers from the nose end without depressing the nose.

These nylon bearings swivel inside their housing to compensate for over 20° of shaft misalignment.

Made of acetal blended with PTFE, these bearings handle speeds twice as fast as standard sleeve bearings.

Ball bearings operate with less friction than other bearings, so they can run at higher speeds.

Also known as tapped-base bearings, these ball bearings mount to surfaces from the bottom through threaded holes. Because of their narrow profile, they’re commonly used in tight-clearance spaces, including systems where multiple shafts are mounted close together.

Machine holes and slots or weld in place.

Machine holes and slots or weld in place.