Clear All
For Load Direction For Load Direction |
---|
![]() | Combined Radial, Thrust, and Moment |
System of Measurement System of Measurement |
---|
|
OD OD |
---|
|
ID ID |
---|
|
For Shaft Diameter For Shaft Diameter |
---|
|
Dynamic Combined Load Capacity Dynamic CombinedLoad Capacity |
---|
|
Static Combined Load Capacity Static CombinedLoad Capacity |
---|
|
Bearing Type Bearing Type |
---|
![]() | Roller |
Lubrication Lubrication |
---|
|
For Mounting Fastener Thread Size For MountingFastener Thread Size |
---|
Construction Construction |
---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
---|
Minimum Temperature Minimum Temperature |
---|
|
Mounting Hole Counterbore Depth Mounting HoleCounterbore Depth |
---|
|
Mounting Hole Counterbore Diameter Mounting HoleCounterbore Diameter |
---|
|
Mounting Hole Diameter Mounting Hole Diameter |
---|
|
Mounting Hole Location Mounting Hole Location |
---|
|
REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration,Evaluation, Authorization and Restriction of Chemicals) |
---|
|
RoHS (Restriction of Hazardous Substances) RoHS (Restriction ofHazardous Substances) |
---|
|
For Housing ID For Housing ID | Show |
---|
|
For Housing ID For Housing ID | Hide |
---|
About Ball and Roller Bearings
More
Face-Mount Crossed-Roller Bearings

Mounting holes on the inner and outer rings allow for fastening onto hollow joints and shafts. The rollers face in alternating directions to allow for rigid, accurate motion under any combination of radial, thrust, and moment (twisting) loads. Use in applications where highly accurate motion is necessary, such as machine tools and industrial robots.
Open bearings dissipate heat more efficiently than sealed bearings.
Sealed bearings block out dust and other contaminants better than open bearings, but retain more heat.
For technical drawings and 3-D models, click on a part number.
Combined Load Cap., lbs. | |||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|
For Shaft Dia., mm | For Housing ID, mm | Wd., mm | Ring Material | Dynamic | Static | Max. Speed, rpm | Lubrication | Temp. Range, °F | Features | Each | |
Open | |||||||||||
80 | 165 | 22 | Steel | 11,400 | 16,100 | 600 | Required | 0° to 230° | Lubrication Groove, Two Lubrication Holes | 0000000 | 0000000 |
Sealed | |||||||||||
80 | 165 | 22 | Steel | 11,400 | 16,100 | 450 | Lubricated | 0° to 210° | Lubrication Groove, Two Lubrication Holes | 0000000 | 000000 |