McMaster-Carr logo
    Filter by
    System of Measurement
    Shaft Diameter
    Attribute Image
    Bearing Seal Type
    Maximum Temperature
    Static Combined Load Capacity
    Width
    Attribute Image
    Dynamic Combined Load Capacity
    Mounting Fastener Thread Size
    Industrial Info Snippet
    For Housing ID
    Attribute Image
    Bearing Construction
    Mounting Hole Counterbore Depth
    Mounting Hole Counterbore Diameter
    Mounting Hole Thread Pitch
    Industrial Info Snippet
    Performance
    Rotation Speed
    Thread Size
    Industrial Info Snippet
    Bearing Type
    Mounting Hole Diameter
    DFARS Specialty Metals
    Export Control Classification Number (ECCN)
    Industrial Info Snippet
    Roller Material
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    2 Products

    High-Load Face-Mount Crossed-Roller Bearings

    Image of Product. Front orientation. Roller Bearings. High-Load Face-Mount Crossed-Roller Bearings.
    With thicker inner and outer raceways, these bearings can handle heavier loads than thin-profile crossed roller bearings. Mounting holes on the inner and outer rings allow for fastening onto hollow joints and shafts. The rollers face in alternating directions to allow for rigid, accurate motion under any combination of radial, thrust, and moment (twisting) loads. Use in applications where highly accurate motion is necessary, such as machine tools and industrial robots.
    Open Bearing—Open bearings dissipate heat more efficiently than sealed bearings.
    Sealed Bearing—Sealed bearings block out dust and other contaminants better than open bearings, but retain more heat.
    Combined Load
    Cap., lbf
    For Shaft
    Dia., mm
    For Housing
    ID, mm
    Wd.,
    mm
    Dynamic
    Static
    Max. Rotation
    Speed, rpm
    Lubrication
    Temp. Range,
    ° F
    Features
    Each
    For Combined Radial, Thrust, and Moment Load—Open with Steel Ring
    902102516,50024,200500Required0 to 230Lubrication Groove, Two Lubrication Holes0000000000000000
     
    For Combined Radial, Thrust, and Moment Load—Sealed with Steel Ring
    902102516,50024,200400Lubricated0 to 210Lubrication Groove, Two Lubrication Holes000000000000000
     
    back to top